needle not locking on

[Get_Swole]

anybody else have this problem you draw with a needle then unscrew screw the other on and it doesnt seal properly. Ive had two so far, in 3 weeks kinda pissing me off. Got it fully in my quad and aspirated and boom it wont even come back down cause its suckin air. I didnt know if it was bad for the gear so i just tossed that shotbut damn anybody else have this happen and they wouldnt seal at all i tried another pin.

 

[hongkongguy]

never,what brand did you use?

 

[dreww]

I would try a different brand or different pins, maybe you just got a few defective ones.

I had a defective bag of 10 slin pins when I was using IGF recently, and they would withdraw liquid, but you couldnt push it out, at any force...I find this out the hard way 5 pins in, and after having pricked my entire body trying to push the igf out..what a bitch!!

I like BD, and Terumo for pins.

that shits happens to me all the time when using igf. freaking terumo.

 

[Get_Swole]

im using terumo's.

 

[teedubgee]

Damn dude, that's the exact same problem I was havin. It happened 3 times during my cycle too. All it did was piss me off though. Jus switched needles again and was set to go.

 

[mikeswift]

yeah I've had it happen as well, it really sucks when you have to toss away a pin full of expensive liquid!

 

[saudades]

Happens the most with Terumo it would seem. Never had a problem with B-D.

 

[winneevee]

I had an issue one time but not since.. I would get new pins..

 

[Get_Swole]

yeah i got some new ones coming they are still terumo's but hopefully ill get better ones...

 

[h8tr3d]

Bump b2see with the BD pins! Havent had a problem yet with em. The best part is i can get 25 inch and a halfs for like five bucks right at the local pharmacy!