Dumb move of the week.

footballcat

Hardly a Newbie
Well im running liquid clomid, and it was getting cloudy, so i decide to boil some water in the microwave. So i put the clomid in there, and 3 min later i look in there, the water got a lil cloudy, then i notice that the bottle is full of water. So i now i have a full bottle of water and clomid, so i dont know what to do?
 
YOu mean that your clomid powder has completely separated into a pellet at the bottom of your vial? If that's the case, than its no big deal. Simply take a glass stirring rod (or even a piece of straitght wire) and resuspend the powder. Keep in mind that if you have evaporated a lot of water off, you will now have a higher mg/ml concentration.
 
No, the clomid started falling out of suspension. So i warm it up to put it back into suspension, and the cap came off. So now it diluted my clomid even more
 
well, if you know how much you had (how many ml), and you know how much is in there now (total ml of solution after dilution), you should be able to do a little math and figure out how much you need to take. Shouldn't be that big of a deal!
 
I'll assume that you had 2500mg in 50m ml. you used 14ml, therefore you have 2500-14x50=1800mg left (alternately, (50-14)x50=1800mg). Now, your new concentration is 1800mg/50ml = 36mg/ml.

From my understanding, you put your vial into some container full of water, and than the cap came off and water filled your vial. Now hopefully, none of the clomid powder came out of the vial into your dish (it shouldn't have, unless the contents of the vial was boiling and sputtering). In this case you would have an even lower conc.
 
bro, you should have saved the powder that came into the dish. It would be a really low conc, but hey, clomid is clomid. You could call it clomid-aid.
 
Back
Top