just want to make sure..

[weight77`]

I am making 10 gams of test cyp...so I put the powder in the vial then add the 2ml of BA...then add the oil (after heating) then put it through the filter and that is it....

does this sound right....I know there are insturctions but just want to make sure I am following it right...

[WeirdAl]

heat the oil to sterilize it, then add the oil to the powder/solvent, then heat again to disolve the powder... then filter

You might want to only add part of the oil (half) before you filter, then run the rest of the oil through the filter. That's what I usually do.

[sundevil]

I agree with Al. Definitely sterilize the oil with heat (before adding hormone). And holding back the oil is good because it can be used to clean the filter, clean out the vial, etc. It all ends up in the final mix with less waste.

[Chemical Evolution]

what they said!

[Julio2254]

If the oil bought is usp grade it doesn't need to be steralized correct??

[Chemical Evolution]

correct!