fina

2BIG

New member
I just made my first batch of fina and i heard that you should bake it a few times at 250degrees to sterilize it.  Then i also heard that bakeing it makes it less effective and that you should boil water and then take it off the heat and put the tren in the water for a few minutes.  What should i do if anything?
 
man.. i have no clue...  i know there are sites out there somehow on the conversion/sterilizaton process.. here's a bump for ya for anyone who knows..

i've taken tren 2 ways.

pellets .. orally dosed..
and GAC's Humatren ...  so i have no clue.
 
OK, here's the deal:

You can bake at 250 (use an oven thermometer to make sure) for 10-15 min.  remove and let cool to room temp.  heat once again same as before.  let cool and done.

Or you can just buy a sterile filter for a buck or two.
 
what I did both times I've made tren was first filter it through a sterilized filter.  Then I baked it at 250 degrees for 15 minutes.  Let it cooled to room temp and then baked it again for another 15 minutes.  Definetely worked good for me.
 
No, the boiling water would not be a high enough temperature to sterilize anything IMO.  When I used to do cancer research, we had to sterilize everything.  The way we went about doing it was to bake it in these huge ovens that went up to high temp to make sure nothing would survive.  Just my .02
 
Put a 20guage needle in the stopper first. Make sure the tip is above the fluid and not in it. Bake it at 250 for ten minutes, let it cool and do it again. Later
 
I've read its not really necessary to bake it, as long as you use the sterile filter... however, I still think its better to be safe than sorry when it comes to your body.
 
Back
Top