Pip halfway through cycle

[Slice07]

Im takin 200 mg of test p every other day. Im on week 5 and the last week and a half ive had terrible pip. The first 3-4 weeks was fine. Im gunna try to pin 100 mg everyday and see if its just the amount causing it. I havnt changed anything, using the same size needle, warming it up like i always do.

 

[drtbear1967]

Have you been warming up the rig before you inject?

 

[Muscle mechanic]

I get same problem halfway or later in cycle, but it's only cause of not rotating. It's from the area not healed and getting sore and repeated injections will start causing pain and soreness.
Simple fix.
These areas give enough rotation.
Upper thigh
Lower thigh
Venoglute.HIP
Delt
Triceps in rear solf area relaxed below shoulder
Then glutes of coarse
I have both sides of body of all these I usually only need to do my glutes, hips, and lower thighs that's it on short esters.
Stop jabbing, find area press one hand pulling skin tight other in pin push pin point against skin and turn back and forth so it sinks. This in these areas works for me. Heat gear up in body of syringe until a couple drops come out of needle from gear expansion. DO NOT GET NEEDLE WET UNDER RUNNING WATER. I always pass a alcohol swab over needle and let dry first. I always pin after shower and use alcohol over area first.

 

[drtbear1967]

I get same problem halfway or later in cycle, but it's only cause of not rotating. It's from the area not healed and getting sore and repeated injections will start causing pain and soreness.
Simple fix.
These areas give enough rotation.
Upper thigh
Lower thigh
Venoglute.HIP
Delt
Triceps in rear solf area relaxed below shoulder
Then glutes of coarse
I have both sides of body of all these I usually only need to do my glutes, hips, and lower thighs that's it on short esters.
Stop jabbing, find area press one hand pulling skin tight other in pin push pin point against skin and turn back and forth so it sinks. This in these areas works for me. Heat gear up in body of syringe until a couple drops come out of needle from gear expansion. DO NOT GET NEEDLE WET UNDER RUNNING WATER. I always pass a alcohol swab over needle and let dry first. I always pin after shower and use alcohol over area first.

Great information!!

 

[OldRazor]

In addition to above, heat the vial up by placing in extremely hot water in sink for about a minute, clean top right away and draw and inject while fluid still really war...

 

[Slice07]

2ml is just too much for my ass to take! Lol like i said in my first post. I warmed it up like i always do. I wasnt gettn sore at first. Last cpl days ive been doing 1 ml everyday and no pip at all.

 

[Muscle mechanic]

2ml is just too much for my ass to take! Lol like i said in my first post. I warmed it up like i always do. I wasnt gettn sore at first. Last cpl days ive been doing 1 ml everyday and no pip at all.

I do 3 ml at a time. Would do more but maxed out lol. Have to do more days to get it in.

 

[EMW14]

2ml is just too much for my ass to take! Lol like i said in my first post. I warmed it up like i always do. I wasnt gettn sore at first. Last cpl days ive been doing 1 ml everyday and no pip at all.

I hear you. 2.5 ml and I actually have slight bruising on both butt cheeks. Gotta try Mechanic's method.