Test cyp

jamesdal1 said:

Hello all,

I hope this is right forum for this.

I make my own gear and my last Test cyp, looks like it crystallized.

Can someone let me know why this happened?

Will heat get it back to normal? Or do I need more BA or BB?

Here is a picture.View attachment 19198

Please let me know.

Click to expand...

Muscle mechanic said:

Use ba @ 2%
BB @ 15%

This is what I would do... to brew

Weight raw figure out correct ratios per weight by total volume etc etc....

- Glass beaker add raw powder for correct weight of your recipe u following.
- Next add ba 2% and bb 15%
- Have a skillet with 1" water on medium
- Put beaker inside heat up until beaker contents clear!!!
- Put carrier oil in oven and heat oil up to around 150 degress.. only use glass not metal.
- Add the warm raw that is clear in beaker to the oil
- Let both get around 150 degrees together

Let's say I may have tried this here or there I never used a thermometer but that is me!!!
- After that u should have sterile things to filter your ......

If using standard amounts it shouldn't crash with just say GSO, bb 15%, BA 2%.
Standard meaning test cyp no more than 250mg/ml

Test cyp will do it if it's say 250-300mg/ml and it changes temp.

But as stated Heat up.
I get coffee cup put water heat only water in microwave until hotter than my sink gets but not too too hot. But to where my finger won't get a blister but never can I tolerate it in water.
Submerge vial but be sure top is above.

Another way is blow dryer that works to reheat into solution.

With primo ace 100mg/ml I have had to hold almost touching burner to get completely back and add into primo e 200.
Half and half mix. I chose that route then.
I ended up with mix
primo ace 50mg and primo e 100mg
150mg/ml total the primo ace wouldn't hold no matter what at 100mg/ml. I didn't make it so I didn't know wtf.....

I have seen someone use bb at 7% and
ba at 2% in test e or c can't remember. It crashed and would recrash by next day.
Heated it up to around 150 degrees added 7% more bb and presto!!!
Re-filtered and all good. BUT it was a positive confirmation that they had used those amounts.

I said alot but also read alot over years...

Sent from my SAMSUNG-SM-G890A using Tapatalk

Click to expand...

jamesdal1 said:

Hello all,

I hope this is right forum for this.

I make my own gear and my last Test cyp, looks like it crystallized.

Can someone let me know why this happened?

Will heat get it back to normal? Or do I need more BA or BB?

Here is a picture.View attachment 19198

Please let me know.

Click to expand...