Can I put 2 different brands of test c in 1 vial?

[Shredhead]

Is it possible if you have 2 1ml vials of test c. From 2 different companies to take out all 1ml of one and put it with the other 1ml..so I will have 2ml all together in 1 vial

 

[Muscle mechanic]

Is it possible if you have 2 1ml vials of test c. From 2 different companies to take out all 1ml of one and put it with the other 1ml..so I will have 2ml all together in 1 vial

Yes

Sent from my SAMSUNG-SM-G890A using Tapatalk

 

[drtbear1967]

Yep

 

[Muscle mechanic]

Is it possible if you have 2 1ml vials of test c. From 2 different companies to take out all 1ml of one and put it with the other 1ml..so I will have 2ml all together in 1 vial

As long as u putting them in a sterile sealed vial glass with top solvent resistant all oils can be mixed each already had been put into solution with appropriate volume of oil and solvents mixing them with not change concentration of either it will only combine they will remain the same except u if u have test c 300 and Boldonone 300, if u combine these u will have 150 mg per ml of each instead of 300 per.
Concentration stays same except u now altered volume molecular weight in solution stays same.
Think I explained it correct

Sent from my SAMSUNG-SM-G890A using Tapatalk

 

[Shredhead]

awesome...thank you for the input

 

[Shredhead]

Quick question, whenever i mixed the 2 there are allot of bubble, they kinda look like white bubbles or something....is that ok?

 

[Shredhead]

ok never mind...heheh i went back to look again and they all gone., looks perfect now... this took about 10min... and yes i am an overly paranoid spazz

 

[Muscle mechanic]

ok never mind...heheh i went back to look again and they all gone., looks perfect now... this took about 10min... and yes i am an overly paranoid spazz

U did vent top with another sterile needle inside to let air pressure out correct?
I have had a top start to melt and expand from whatever solvents didn't agree with it. I couldn't even push needed thru it. It was sticky like gum. I pulled it off and drew and put into another vial had no problems

Sent from my SAMSUNG-SM-G890A using Tapatalk

 

[Shredhead]

No i did not put a breather needle in it..grrr...it went in ok, kinda hard but next time for sure a breather in it

 

[Muscle mechanic]

No i did not put a breather needle in it..grrr...it went in ok, kinda hard but next time for sure a breather in it

It's easy with vent. As u stated u see bubble like stops.
Get coffee cup.
Heat water in microwave in cup
Heat it to where u can't put finger inside but can touch water for second
This is what I do.
Add sterile needle without syringe and submerge till all oil under the hot bath
Let it sit for a while as long as it takes
This will put all of into one solution together without the drifts he are seeing.

Drifts I call what looks like water mixing with oil. White bubble type Drifts.
They are pockets of solvents not breaking down or mixing together.
Heat will always get the job done.

Sent from my SAMSUNG-SM-G890A using Tapatalk