Solvents and Oil

When making a brew, is it better to mix the powder, solvents, and oil all at once until it dissolves or mix the powder and solvents first and let dissolve and then add the oil?

Certainly bro add solvent first then oil would be better, please advise the following recipes as example:

Test Enanthate 5 gram conversion
Needed
5 grams test E
1ml Benzyl Alcohol = 5% BA
15.25 ml sesame oil
Syringes 3cc & 5/10cc
18 or 20 gauge needles
mixing Vial
Sterile Vial
Whatman sterile filter

1. Weigh out 5 grams of powder.
2. Place powder in vial.
3. Add BA to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach Whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though Whatman filter.
10. Take other syringe with 2ml oil, run through Whatman into solution.
Makes 20ml @ 250mg/ml

yeah i would think letting the steroid powder fully dissolve in solvents first then adding the oil would be better

Agree. And you can warm the carrier oil in the same pan when you wait for steroid powder to be fully dissolve. Speed up your work.

Presser said:

yeah i would think letting the steroid powder fully dissolve in solvents first then adding the oil would be better

Click to expand...