Hi all,
I wonder if someone could shed a little light on a problem I am having right now. I am cooking both Test Enanthate and also Test Propionate but having a lot of problems with the propionate as its not disolving in the BA/BB. I have already made up a batch of 60ml @ 100mg/ml but it is very cloudy and I can see the crystals floating in the suspension/oil.
What is the best way to heat it in order for it to be disolved properly? I did try to use the same way as for the Enanthate, i.e. place it in container and add heat through placing it on to the heat in a water bath. This worked fine for the enanthate as it has a low melting point of around 33C but propionate's melting point is 118-122 so, no way for it to melt by boiling it. Which way do most people do the heating to get it to melt? Oven? If so, we do have a gas oven so should I put it in there and set the heat to say, 125C and then wait for it to melt? What about the BA/BB? When would I add/mix these in? I am trying to keep the BA/BB low (2%/6%) so would this be a problem too?
Thanks for any and all information on this, I want to get it right but as its my first endeavour doing it, even though I have ready everything that I can find on the subject.
Regards to all,
I wonder if someone could shed a little light on a problem I am having right now. I am cooking both Test Enanthate and also Test Propionate but having a lot of problems with the propionate as its not disolving in the BA/BB. I have already made up a batch of 60ml @ 100mg/ml but it is very cloudy and I can see the crystals floating in the suspension/oil.
What is the best way to heat it in order for it to be disolved properly? I did try to use the same way as for the Enanthate, i.e. place it in container and add heat through placing it on to the heat in a water bath. This worked fine for the enanthate as it has a low melting point of around 33C but propionate's melting point is 118-122 so, no way for it to melt by boiling it. Which way do most people do the heating to get it to melt? Oven? If so, we do have a gas oven so should I put it in there and set the heat to say, 125C and then wait for it to melt? What about the BA/BB? When would I add/mix these in? I am trying to keep the BA/BB low (2%/6%) so would this be a problem too?
Thanks for any and all information on this, I want to get it right but as its my first endeavour doing it, even though I have ready everything that I can find on the subject.
Regards to all,