Help, My Testosterone Crashed.

Iron Game

Veteran
crashed.jpg



Here is trenbolone enanthate. 1st is crashed with crystals in the oil. Almost 250mg/ml in grape seed oil. 2nd pic is after 15 minutes at 180f. There is some sludging from the active ingredient still not completely in solution. 3rd pic is after another 10 minutes at 200f. There was still a little sludge so i shook it a bit and it completely went back in to solution. I have it put to the side. We’ll see where it’s at in a few days. Cap, stopper, etc were never removed and ther was no venting. Venting is only necessary if your trying to remove moisture. Here are pics.

crashed1.jpg
 
Be careful tren doesn't like heating up above melting point. I would't go above 176F. You will destroy hormone.
 
Man the title of your post said testosterone, but you speak about tren. Is the test or the tren what is crashed?? For tren you will need 20% bb to be sure it will not crash. I had experiences like this with tren trying to lower the bb, but at 20% i never ever had a problem, even in cold or warm countries. In your case i will add bb to make it higher to 20% while heating. I hope that will solve your problem. That will also make lower the concentration


Sent from my iPhone using Tapatalk
 
Thank you bruthas for the replys. I posted this for a friend and will verify the hormone.

Just like Giru said, is it testosterone or tren enan? Looks crashed badly. Did you know your friend's recipe? And the brewing process? Because its crashed could be caused by many factors.
 
Just like Giru said, is it testosterone or tren enan? Looks crashed badly. Did you know your friend's recipe? And the brewing process? Because its crashed could be caused by many factors.

Completaly agree. Crashed can be from a melted filter for example, for ipa that was left in the vial or rubber stopper(if you sterilize your own vials), too little bb, like i said, for tren i will go to 20%. Give us more info when u have it bro and for sure we can figure out how to fix it


Sent from my iPhone using Tapatalk
 
This is a normal crystallization phenomenon , especially where the temperature is relatively low, you only need to heat it, the crystal will dissolve , i suggest you reheat them before using them .
but i think you'd better check a recipe again
 
I've only seen this when you filter gear that is too hot. The filter paper gets destroyed and doesn't filter properly. Let it cool down, then filter again with new filter.
 
Back
Top