Trenbolone Enanthate

[Julio2254]

Anyone got instructions on converting trenbolone enanthate at around 200mgs/mL? Is it quite similar to making test E?

 

[Julio2254]

So to bake up a 10 gram batch and get 200mgs/mL in 50mL, would these numbers work?

2.5mL BA
5mL BB
42.5 mL Oil ( im not sure how much room the powder would take so im not sure on the oil number)
10 grams powder

Also is there a need to heat in order to get the powder into the solution? Do you think this formula would work and be painless?

 

[WeirdAl]

That sounds good except for too much oil. In general, powders take up .85ml/mg, so you'd probably need to reduce your oil by 8.5ml. And I'd guess you'd need to heat, but I'm not certain

 

[956Vette]

I am using some right now that i made with 3%ba and 12%bb, and it is painless

 

[Presser]

fuck i didn't realize guys were making their own injectables back in 2003, lol, just came across this thread and kind of through me for a second

 

[Powderguy]

Especially Tren E..that wasn't very produced then. It was Hexa (original tren) in its place. I remember making androstenadione back then and it was a huge seller.(through my employer of course)

 

[Presser]

you made andro? how and how hard was it

 

[Powderguy]

An advanced chemistry set, and chemicals you can make a ton of AAS like substances (I word it that way for certain reasons).
Not difficult, orals are easier and 19-noras the easiest in their category.

 

[thx]

Has any of you guys made it with only BA?

 

[guysp30]

That would be interesting! Instead of making your own injectables, making your own raws!