starting a brew need help

[d12hazz]

Ok, I am new to this and going to take the big leap and purchase some powder. After a lot of research and some serious contemplating I decided who to buy from. My question here is being that it is my first brew is there an easier test to brew (idiot proof)? If some one could help I would greatly appreciate it. I wanted to brew some sustanon but can't find any receipts. Up for any suggestions. Thanks.

 

[Presser]

yes i would start with something super simple like testosterone Propionate, its super easy to work with and hard to fuck up

 

[d12hazz]

Cool.... Thanks brother!

 

[DefMetalLifter]

I don't brew but most guys that start seem to start with the test prop

 

[d12hazz]

Thanks for your response, i really appreciate it.

 

[Powderguy]

Test Enanthate is an easy one to start with. Use .9% BA no BB and gso..smooth as butter.

 

[charliebigspuds]

Defo test E supper easy and no pip. My prop is a killer. But then again who's aint.

 

[Powderguy]

Prop can be a painful first time brew. Test E and prop would essentially cost the same but Test E is much easier to brew and once a week injections.

 

[BEASTZ6]

Prop is stupid easy to brew at 100 mg/ml. I have never tried to push it to a higher concentration.

 

[Powderguy]

I do Prop at 200. Test E can go 400 easily. I don't get PIP from either.

 

[d12hazz]

Test Enanthate is an easy one to start with. Use .9% BA no BB and gso..smooth as butter.

Going to try this. Got my powder today, should i do a melting point to test firs?. Going to start it tomorrow.

 

[Powderguy]

Are you using test enthanate? If so take a small piece and put it in your hand, does it melt, feel waxy and have a distinctive smell?
Get your supplies ready, Raw, oil, solvent and empty vial or jar whatever your using as the container, hopefully something glass.

If so then dissolve it in your solvent (BA) and gently heat it in warm boiling water (swirl the bottom of the vial around in the water and don't let water in it) until its completely dissolved (the test and BA) , remove from heat and slowly add your oil, swirl, warm again, swirl let cool to luke warm and filter-too easy

 

[d12hazz]

Definitely test e...... Thanks brother! I'm super stoked.... can't wait to try. I will post results.

 

[Pristi1340]

good luck bro, its pretty easy tbh! which oil are you using?

 

[d12hazz]

good luck bro, its pretty easy tbh! which oil are you using?

Im using GSO.

 

[Powderguy]

Filtered or USP grade? Do you have a couple .22 um filters?

 

[d12hazz]

USP grade and I have a shit load of.22 filters, for syringes and a filtration system.

 

[d12hazz]

Test Enanthate is an easy one to start with. Use .9% BA no BB and gso..smooth as butter.

Would you mind telling me the recipe for 10g of test E with the above info. I was going to use another recipe found on here but it has EO and BB (which I have both). I would like it to be 300+ mgs/ml if possible. China powder and not to sure of it's purity.... Thank you.