Transfering problems, need advice asap

[Santo224]

Whats goin on guys, im in not happy at all, i got my order of A-S gear today and had alot of problems transfering it from the satchets, lost just about all my gear. I dont know what hapened, i never had any problems transfering before. I made a whole with a 23 gauge and stretched it around a bit my rotating the needle then changed it with an 18 gauge to withdrawl, then changed that with a 23 gauge, when i went to inject into the vial nothing was coming out i squeze as hard as i could and tnothing, then all of a sudden all the gear shot out the top of the syringe lost just about half of my deca, i continued to inject the reaming eca real slow took about an hour. Then with the sust i had the same problem, so against my better judgement i tried to inject the remainder of the sust with an 18 gauge, but now there is a noticable hole in the rubber, is the gear i was able to save even safe to use now, what do you guys think, should i just chuck it or try and use it, i have about 10 ml of deca saved, and about 15 of sust. Sould i just count my losses and chuck it or what, any advice would be appreciated, thanks guys.

 

[teedubgee]

Next time jus draw out what you would need in each syringe and jus set them aside for future use (pre-loading). It's possible, but very difficult to inject gear into a pre-sealed vial. When you inject more liquid into it, there's no place for the displaced air to go. Now I'm jus talking out of my ass here, but I bet you could inject another syringe in the vial at the same time with it's stopper fully depressed. That way the air would have somewhere to escape to while you inject your gear. Anyone see what I'm getting at here? Or has anyone actually try that shit? Anyway as far as the left over gear goes, I'd keep it and use, but only cuz I'm cheap like that

 

[teedubgee]

Better yet, jus stick another needle (no syringe) in the vial while you inject the gear into it. That should allow for an exit of the displaced air.

 

[Santo224]

Thanks alot man i think i will, do you think the whole form the 18 gauge pin will be a problem at all, no juice is leaking out of it or anything, but you can see it,

 

[teedubgee]

I think you should be straight, be I'd bump for more opinions

 

[Spiderman]

you're right on with that teed...put another needle in the top of the vial (preferrably not an 18 gauge) and that will equilze the pressure built up when you inject your gear!

 

[Santo224]

Thanks fellas, i really appreciate the input, but BUMP! for more opinions, any experiences would be appreciated, thanks again guys.

 

[bigbaldbulldog]

I always introduced a syringe full of air into the pouch so there is no vaccum and air pressure is greater inside the bag then outside..