crashed gear

dorian123

dorian123

New member
anyone have any experience with crashed gear? been doing this for about 15 years now and this is a first for me...

got my gear for a good source that I have used before, everything looked fine-went ahead and ran it through a whatman into a sterile vial as usual

on the road and had the test E in my over night bag, temp wise probably 50F, took it out today to do my TRT and it looked like a slushy

about 30 min at room temp it melted back to a liquid

all the research I've done says it should be fine-any suggestions?
 
Weird lol if it melted back into solution me personally I'd shoot it... Or you could always heat it back up
 
dorian123 said:
anyone have any experience with crashed gear? been doing this for about 15 years now and this is a first for me...

got my gear for a good source that I have used before, everything looked fine-went ahead and ran it through a whatman into a sterile vial as usual

on the road and had the test E in my over night bag, temp wise probably 50F, took it out today to do my TRT and it looked like a slushy

about 30 min at room temp it melted back to a liquid

all the research I've done says it should be fine-any suggestions?
Click to expand...

its fine to use brutha! And if it went back to full liquid at room temp on its own without you having to heat it then you didn't lose any potency! And truth be told, in my experience, the gear thats usually over dosed a tad is more likely to crash a little bit, so thats a good thing in my book, not sure how scientific that is,lol, but anyhow yeah ur gear sounds like its fine daddio
 
it's good to go brotha. As presser said, it's usually the high dosed vials that have a hard time staying in the solution (test 400, sust 500, etc). Any gear can potentially crash if exposed to low temps, but if it melted back down at room temp then it's perfectly fine to use. In the future if it doesn't dissolve on its own you can put the vial in a pot of hot water on the stove, or heat it with a blow dryer.
 
.....And make sure you vent it. The carrier oil is light and the dose is possibly a little heavier that the carrier oil and min solvent. If it blended back into solution at room temp, like everyone said its good to go. Just look for particles in your solution before injection
 
Happens to me every so often, especially with Cyp 300. I just heat it up on my glass top stove. And in about 2 weeks it will do it again. Repeat then it's gone. I knew it had a 75% chance it would any cyp over 250 IS BOUND TO
 
parabellum said:
Happens to me every so often, especially with Cyp 300. I just heat it up on my glass top stove. And in about 2 weeks it will do it again. Repeat then it's gone. I knew it had a 75% chance it would any cyp over 250 IS BOUND TO
Click to expand...

75% ay lol,
 
lol here we go with the percentages again..we know how much you love it when we do that Presser.lol
 
parabellum said:
Happens to me every so often, especially with Cyp 300. I just heat it up on my glass top stove. And in about 2 weeks it will do it again. Repeat then it's gone. I knew it had a 75% chance it would any cyp over 250 IS BOUND TO
Click to expand...
I've had cyp and enanthate 400mg/ml and it never crashed.... Ever... Idk where ur buying your oils at lol
 
You know, that's what I thought! But it's only the cyp 300. Nothing else except one TNE. But that sat in my car last winter. It fell out of my pocket lol
 
parabellum said:
You know, that's what I thought! But it's only the cyp 300. Nothing else except one TNE. But that sat in my car last winter. It fell out of my pocket lol
Click to expand...
I hear some people have those issues especially when it's shipping and it's cold out...
 
Last edited:
some research that I have done states that people will do a freezer test-to see if anything is in the oil...if it freezes it shows that something is in the oil doesn't show what but there is something there-good thing from what I've seen is if it has EO it won't freeze, so I'm pretty sure there is no shitty EO there
 
test is an oil-when oil freezes it never really freezes, but will separate from any solution. However the carrier is also an oil and if theres a mix of oils its hard to tell.
So bottom line the freezer test wont tell you anything other that science works..lol
 
Powderguy said:
test is an oil-when oil freezes it never really freezes, but will separate from any solution. However the carrier is also an oil and if theres a mix of oils its hard to tell.
So bottom line the freezer test wont tell you anything other that science works..lol
Click to expand...

yeah that's what the test is suppose to tell if there is anything in there-not saying what it is but that there is something there

if it freezes you know there is no shit EO in there
 
I hear quite a few suppliers have been trying out coconut oil as a carrier lately...Everyone of them have run into issues with it becoming gel-like when the temp drops...I only know of one supplier in particular that has actually stuck with it and convinced their customers to deal with it, the rest I have spoken to have not gone back to it again.....
 
You must log in or register to reply here.

Similar threads

Muscle Insider
The Morning Dose #25: Ozempic Overdoses, Hollywood TRT, and the Relationship Between Protein and Mental Health
Replies
0
Views
89
Muscle Insider
Muscle Insider
Muscle Insider
The Morning Dose #27: Anti-Aging Peptides, Ozempic Plateaus, and How to Screen Your TRT Provider
Replies
0
Views
86
Muscle Insider
Muscle Insider
Muscle Insider
Rich Gaspari Calls Out Bodybuilders Neglecting Calves: ‘Seems Calf Isn’t As Important Today’
Replies
0
Views
236
Muscle Insider
Muscle Insider
Muscle Insider
Jay Cutler on New-Gen Athletes Openly Discussing Anabolics: “They Need to Be Careful” 
Replies
0
Views
150
Muscle Insider
Muscle Insider
Muscle Insider
Blome Research Review – Legit or Worth it? (+ Alternatives)
Replies
0
Views
97
Muscle Insider
Muscle Insider
Back
Top