PDA

View Full Version : Winstrol Inj. problems



Deezil
01-16-2003, 11:58 AM
Tried to inject 100mg/ml of stanol V with a "20" gauge pin...winstrol would not inject...WTF is the problem?

ken69dahl
01-16-2003, 02:19 PM
Need to shake it up real well, maybe even inject with an oil based gear in the same pin.

BStrongBwell*
01-16-2003, 06:35 PM
YUP, that's very frustrating... ken is right on the mixing. That will definitely help.

jake steed
01-17-2003, 02:11 AM
My friend used a 25 guage needle with the ttokyo 100mg and didn't have any problems.. go figure..

jake steed
01-17-2003, 02:12 AM
Shake the bottle

TAZ
01-17-2003, 08:47 AM
Originally posted by ken69dahl
Need to shake it up real well, maybe even inject with an oil based gear in the same pin.

This will work. Stanol V is notorious for that. Mixed with an oil based AA's like tren mekaes it slide smoothly through the small ga. stuff.
-TAZ

jake steed
01-31-2003, 02:39 AM
Hey I was having probs with 50mg in a 23 guage this time.... I think it depends on the batch. I don't think they are consistent. I have been through several bottles. Some go smooth through 25 some don't and I always shake em. Go figure?

dpsquat
01-31-2003, 08:41 AM
because its been so called in most parts of US you should run under hot tap water prior to injecting

bigdan
01-31-2003, 08:54 AM
my buddy always draws up the winny then a little oil on top .
then when it comes out the oil lubes the pin and it does not clog.