Bases ...

Does anyone know or have any experience with successfully converting various bases into solution in oil ... i.e. test base, nandrolone base, and boldenone base?

I have seen a lot of talk, and potential recipes, but have not found too many people that will state they have done the conversion themselves with success ... I just can't imagine that it will go into solution with just BA and BB without some other sort of co-solvent ...

I have seen the thread for "painless TNE" posted on several boards, but I fail to see how 10% BA can be called painless ... also, I have not found anyone that has actually DONE this conversion ... any info will be appreciated ... thanks

I have never tried but what I have seen a lot of people have success with is using peg as a carrier with BA & BB.

Bases ?

I'm just wondering why you wanted to use bases. If you want something short-acting, there's alwyas DB and Winny...

And they say you get better results with more even blood levels thru the day, which bases just ain't gonna give ya.

Re: Bases ?

Fox500 said:

I'm just wondering why you wanted to use bases. If you want something short-acting, there's alwyas DB and Winny...

And they say you get better results with more even blood levels thru the day, which bases just ain't gonna give ya.

Click to expand...

First off, winny does not even come close to being similar to nandrolone, boldenone and test ... winny is one of the pieces of the puzzle, but it does not have the action I am looking for ... and as for consistent blood level concentrations, any of the bases can give fairly consistent concentrations with ED injects ... I could give many reasons for using these bases, but do not have the time to go into it right now ...

As for DB ... I'm assuming that you are referring to dbol? Not sure what you mean by this ... and if it is dbol, yes it is a good fast acting product, but it is not the all to end all ... the base powders are there for a reason ...

For what purpose? 2 x a day would really be needed to keep somewhat steady BL, like suspension.

I tried spidies recipe for test suspension. I and two others tried it, the finished product which is close to 70-75mg/cc. There is no pain from the injections, no soreness that usually comes with a suspension shot. I shot this into traps delts, lats, all three heads of triceps, quads, and all with a insulin 100unit syringe, or sometimes with a 25g 1 inch needle. I did modify the recipe a little by adding some more ba. Before adding more BA, I got occasional blockage in a 25 guage pin and in an insulin pin. As the vial became closer to empty, about 2 weeks later, there would be white hard clumps of test clinging to the rubber stopper. I would reheat vial by putting on Mr. Coffee burner for 15-20 minutes and shake hard. All the test would slowly re-disolve and the I would shoot it while still warm. Bottom line it can fall out of suspension after a couple of weeks, but since I have gon to about 7-8% BA, I still get painless shot, (insulin syringe) and it just plain kicks ass for lagging bodypart if site injected. You can really feel it kick in an hour later or so, and it just seems like you don't run out of energy in the gym. I feel very focused as well, but if you were border line temper fit material, you would probally get in trouble with it, as far as aggression goes. I never really bought into the whole agression thing, but I did notice a little more intensity in my thoughts when cut off in traffic or whatever. No pain though is really nice, and the ability to go up or down almost immediatlely with the dosage is nice, 2 days later after no more injections, you are truly "off"!

If the base is suspended in oil then 2X daily shots are not necessary. I would say you should run 2X is it was in BW but not oil.

hangslo said:

Does anyone know or have any experience with successfully converting various bases into solution in oil ... i.e. test base, nandrolone base, and boldenone base?

I have seen a lot of talk, and potential recipes, but have not found too many people that will state they have done the conversion themselves with success ... I just can't imagine that it will go into solution with just BA and BB without some other sort of co-solvent ...

I have seen the thread for "painless TNE" posted on several boards, but I fail to see how 10% BA can be called painless ... also, I have not found anyone that has actually DONE this conversion ... any info will be appreciated ... thanks

Click to expand...

I think this can be achieved by using endotoxin free cyclos, these make painless and smooth injections and is ideal for base compounds.
There are other ways to administer AAS using cyclos such as sublingual, nasal spray, transdermal.
I know of someone who made a small batch of Test base and he filtered twice ( .2um and .1um membrane resppectively )to make sure "he says" remove endotoxins...??? He used the regular cyclodextrins you can buy at 1fast400. he also claimed they were smooth and painless and could be injected IM or Sub-Q.
There was a canadian lab ( QFS ? ) that was making cyclo bold and there were good reports on it.

Carlito