Help with test conversion

I recently got some test cyp powder, and I'm having trouble converting it. I used 5% Ba, and it didn't mix well. I upped it to 6-7%, and it still wasn't easily mixed. I don't wanna run the ba any higher, cause it burns me. I'm wondering if I can add 5% BB? I just want the solution to mix a little easier before I add the oil, otherwise it seems to clump up and clog the filter.
I'd appreciate any help you guys can give me...
Thanks in advance.

ok with test cyp heated oil is best and then add the ba and the bb if you add any bb at all with it. I never do just ba.
I heat the oil then add the cyp a little at a time to dissolve or semi dissolve it then add the ba then heat again and mix well until all is dossolved then filter into clean sterile vials.

Ba is uaually only used to hold solutions together with a high mg/ml ratio or to help even out the solvent for less pain upon injecting.

this is true for mixes but usually not individual mixes (there are some expeptions)
try heating your solution in a water bath this is water on the stove with a cup inside of it with little water so it heats but not directly touching the pan.

try adding the oil after heated then add 1.5ml BB heat and swirl. then see if it mixes it should at this point.

cyp is a poain in the ass or your pwder is not pure and it will not mix easily unless heated.

i have see and had some powders sent domestic do this, however none from overseas sent directly..wonder why? maybe its cut i dont know.

Thanks a lot Crimson, that cleared up a lot of confusion. I did preheat my oil, but it still clumped up. I didn't mix it very hard, I just swirled the bottle. Should I cap and shake? I'll try it with the BB next time just to make sure. Hopefully this will go well. I find this "homebrew" subject fascinating. I can't get enough.
Thanks again...
Karma

I would have added 3X the bb as ba....that stuff is gonna sting as your getting up there in the %. I usually start at 2.5-3 ba and 7.5-9 bb works for damn near everything.....What mg/ml you making it at?

I'm making it 250mg/ml. I'll try your ratio.
Thanks...

you probably wont need even that much ba for cyp