reveremuscle
New member
I have 1ml of pre-mixed IGF, going to add another 2 ml to make it easier to measure. Question I have is, does adding BW to the pin really make any difference? Does anyone just draw and shoot?
Injecting IGF
- Thread starter reveremuscle
- Start date
TomSizeMore
New member
I didn't add any BW to the pin when I shot b/c I saw another post that said it would jepordize the IGF's potency.
reveremuscle
New member
How much did you use? I was debating between 40 and 50mcg PWO. How were your results?
reveremuscle
New member
1 unit = 10mcg (assuming 1000mcg per 1 ml)????
TomSizeMore
New member
reveremuscle said:
I was going to go at 60mcg/day but once I saw the bottle, I decided it would just be easier to go 100mcg/day for 30 days. this made it alot easier to measure out in the pin.
Results where very good!
I just drew up to 30 on the pin with bac water then 60mcgs of igf for 20 days then 100mcgs igf for 10 days.Split these into a am and a pm shot. Draw the water into the pin first then the igf so the water pushes all the igf into the muscle. Results were excellent. Did IM in the biceps and in 30 days went from 18 1/4" to 19"
reveremuscle
New member
Kena,
Did you take any precautions not to get any bac water into the IGF?
Did you take any precautions not to get any bac water into the IGF?
You could prolly just draw the B water up second. Just draw your IGF pull the plunger back a bit and then hold the plunger when you stick the pin into the b water vial and pull back. Make sure you are holding the plunger when you go into the b water vial or your IGF might get sucked into the vial when you stick the pin in.
Maybe someone knows 100%, but does B water effect the IGF in anyway?
Maybe someone knows 100%, but does B water effect the IGF in anyway?
Similar threads
