why does prop - enanthate mix look milky

hi guys, hope you canhelp me with this.

i made a mix with 100mg propionate and 150gr enanthate with 5% Ba, and 15% BB. the end product looks a little bit 'milky'; the solution is not totally clear. i filtered it 2 times with a 0.22um filter, so there are no cristals ore stuff in there, i just look like there is a drop of milk in there or something like that.

i tried to make this test mix two times and botht times it looked like that. i made many other solutions before and never had the problem. is it possible to mix prop and enathate this way??

greetz

yeah, its possible, and I would be real concerned about the milky appearance honestly. I got into it with a sup a yr or so ago about this and their response was certain compounds will appear this way when proccessed into inj. Basically he said humidity storage temp, things of that nature can play a part of it. I've had this happen many times with tren, and both the cloundy and clear were good stuff, so I wouldn't be hesitant to use what you've got.

ok thanks. when i put the solution iin a syringe and i put the syringe in the microwave for about 1 minute the solution is not milky anymore, but when it cools down i becomes milky again.

i injected 2 times now, both times 2ml and did not have any problems, no pain, no infection nothing, so it seems there is not a real big problem, it only looks shit . but if it still works what the hell, just shoot

WHy are you putting the syringe in the microwave?

because i use a thin needle, heeting up the gear makes it go more easy through the syringe while injecting. and also i have noticed when injecting gear that has been heated just before injecting i feel less the day after.

so true, but 1 min in the microwave? I would be concerned that would damage the hormone. I run it under really hot water for maybe a minute. Something I have noticed is that if you preload them, and let them sit till you get to them (say 3 days to 2 wks) the go in like a champ, flow is great and quicker than shit, thats what I've been doing other wise with this nnp/prop mix I gotta beat it in with a fucking hammer

can you help me out a little bit more, how is it possible than when i heat it up it becomes totally clear and when it comes to room temperature it again looks a little bit milky?
today i opened all the 20 10ml vials, put them in a glass beaker, add 5% more BB (so total now is 5% BA, 20% BB), heat it up a lot, and it looked totally clear. after a few hours when it was back to room temperature again it looked a little bit milky. how is that possible? how do i get the milky look away? doest the prop (100mg) and enanthate (150mg) mixture needs more BA or BB when it is 250mg/ml???

1 minute in the microwave? in a pin??? I'm confused, for starters the needle on the pin is metal and will melt the plastic around it. Secondly that small of an amount would boil in a minute in the microwave and boiling it will definitely change it. I wouldn't use it bro until you do some more research or get it tested...

Just run your loaded syringes under hot water for 30-60sec before injecting. That's what I do b/c I use 25g pins. I would never dare microwave any hormone, especially when it is inside a plastic syringe.