viagra conversions?

does anyone have any good viagra recipes, either caps, or suspension?? I tried searching and didnt come up with much

Can't help you out much with any recipes, but i found it cheap enough to buy from a few online pharmcies and save the hassell of brewing this stuff. They have sick deals online.

i can make 1000 100mg doses for $250. Thats damn cheap!!

This is very True....Let me know how that works out for you that is very tempting route to take after putting out those type of numbers lol

so you have 10 grams. You want to make 100mg caps or 100mg/ml.

Liquid solution is easier. You simply take about 1000ml of solution and dilute. When I diluted I just used 1000ml of everclear. I put them in 50ml bottles with dropper and when I used it I just shake and draw. I did this for anavar powder too.


Capsules can be time consuming. You decide what type of filler you want (light-low density) to use and take 990 grams of filler mix you ten grams of viagra mix very well for equal distribution then you get the big empty gel caps the "000" or is it the "0" size ( I forget)cap size I believe which hold up too 1000mg. that would give you 1000 caps with approx 100mg viagra and 900mg filler. or get the "00" 500mg caps and get 2000 50mg caps.

The exact figure on caps will vary by a mg or two because it depends on the density of the filler. I never went that route because I dont have the patience for capping that much which is why online sources use liquid solution.....I dont know what they use as the filler but I notice that it settles at the bottom and you have to shake which is no biggie to shake a little for a boner.

Hell im sleepy. Correct my math if im wrong........but you get the idea.

Cyphon said:

Hell im sleepy. Correct my math if im wrong........but you get the idea.

Click to expand...

so it will basically stay suspended in everclear?? You dont need PEG 300, or 600? So if i have the powder and everclear, im good to go?

I have some in PEG and it doesnt dilute......the powder stays on the bottom but when you shake it it distributes evenly. Anavar doesnt dilute so I shake.

If you dont mind everclear test it out. try 1 gram in 10-20ml.

When I had a good powder guy the stuff diluted very well. Another batch I had was obviously cut because 25% of it sunk to the bottom.

BTW take it easy on the leftover everclear.lol

Heres what I did to get it to suspend.

Take 1gram of Viagra and pour in 19ml of everclear (To get 50mg/ml--20ml by volume).

Put some water in a pot and get it going to a nice boil. Lower the flame or shut it off.

Put the vial containing the everclear/viagra mixture in the pot for three (3) minutes.

make sure water level is adequate-about 3/4 the height of the vial.

After three minutes take the vial out screw or cap it then shake.

Keep your stove flame on enough to keep the water in the pot to a boil or near a boil.

Put the vial back in the Boiling water for another 3 minutes.

Shake again. You should be suspended now. Depending on quality (cut or not) of powder some people add peg300 ( varying amount until desired effect)to the mix but only if suspension fails with the everclear only.

* Note some of the solution will evaporate in the boil so if you need to be dead on accurate you will want to add more everclear or peg to make up for the small amount lost.

Personally I had a solid powder store and Everclear was all I needed.

Good luck any route you go.

Cyphon said:

Heres what I did to get it to suspend.

Take 1gram of Viagra and pour in 19ml of everclear (To get 50mg/ml--20ml by volume).

Put some water in a pot and get it going to a nice boil. Lower the flame or shut it off.

Put the vial containing the everclear/viagra mixture in the pot for three (3) minutes.

make sure water level is adequate-about 3/4 the height of the vial.

After three minutes take the vial out screw or cap it then shake.

Keep your stove flame on enough to keep the water in the pot to a boil or near a boil.

Put the vial back in the Boiling water for another 3 minutes.

Shake again. You should be suspended now. Depending on quality (cut or not) of powder some people add peg300 ( varying amount until desired effect)to the mix but only if suspension fails with the everclear only.

* Note some of the solution will evaporate in the boil so if you need to be dead on accurate you will want to add more everclear or peg to make up for the small amount lost.

Personally I had a solid powder store and Everclear was all I needed.

Good luck any route you go.

Click to expand...

i tried capping, and it sucks, so im going with the everclear....actually im gonna use graves (190 proof)

Let me know how it goes.Im bout to get some var and cant seem to find a solid answer on wether to just use everclear,peg or both.

viagra suspends great in grain alcohol like everclear, you buy the 1oz/30ml dropper bottles from specialtybottles.com and i make each bottle 1.5 grams of viagra, so each ml is 50mg viagra or cialis , and the full dropper equals 1ml and each 1oz bottle is 30ml

and yes its cheap to buy and make loads of money with