I just went through a FF kit with the est solubilizer and ened up with around 7.5grams of test prop. Dried for 5 hours in 150F oven and ended up with fluffy white powder that I diced up. I noticed that the ingredients 'crashed' back out of solution over night. They readily go back unpon heating in a pan of hot water over the stove. What could I have done wrong? Could an incomplete drying cause this? The reason I ask is because there look like little dropplets clinging to the top of the vial when it is heated in boiling water. They look thinner than oil. Could this be water left behind, and what can be done at this point if that is the problem?
THX
THX
