Prop/Enan Blend
- Thread starter Mad-Bull
- Start date
Eat'n Big
New member
That right there is what I was trying to say, you just worded it better.:thumbsup:lol
had to bro,lol, too many guys think adding 100mg/ml of prop and 150mg/ml of test e will yield that per 1ml, they just dont get it,lol
Ok so you guys are stating make and mix Here's what I'm getting from that. This is theoretical. Say I make 5ml of 100mg/ml Prop, 0.5 grams of powder, 0.1ml BA, 1.0ml BB Then make 5 ml of 150mg/ml Enan, 0.75 grams of powder, 0.1ml BA, 1.0ml BB Would I be able to mix them both after heating prior to filtering, filter them together and then bottle final filtered compound. Theoretically of course.
Eat'n Big
New member
No because each will cut the other, make the concentration of the ester dosed higher, then mix, the ratio will cut itself by the other oil.
most deff use the enth, and not cyp , cause cyp is a pain in the ass keeping stable when trying to make it higher dosed for reasons like this. enth is much easier to work with. no need for higher BA either you'll have enough in there as is, anymore you will be selling this mix to a much hated friend of yours!
no bro if ur going to make them seperate and then mix them you will have to double eaches dose per ml so when combined they will yeild the dose ur looking for per 1ml
So again you need to make 200mg/ml prop and 300mg/ml enanthate so that when combined they are 100mg/ml prop and 150mg/ml enanthate. It doesnt matter how much you make of each total, what matters is the dose of each per ml
you could always just make it all at once though combinding the prop & enanthate powders together which might be easiest, but i havent a clue how to make them from scratch with powder but im sure some people here know exactly how to
Eat'n Big
New member
Bingo
Similar threads
