what temp is too hot?

M

mkueffner

New member

• Jul 22, 2013

• #1

just brewed my first batch of test p and was wondering. how hot is too hot. I just want to make sure im not degrading the hormone

 

C

csuperman

member

• Jul 23, 2013

• #2

the melting point is 118-123 °C so if you stay just above that I would imagine you would be good as you have to melt it to get it into solution correctly

 

Presser

Admin

Staff member

Administrator

• Jul 24, 2013

• #3

I've heard of guys not even needing to heat testosterone propionate powder, its very soluble with ba and bb in safflower oil and wont crash

 

BEASTZ6

Full Access

• Jul 25, 2013

• #4

That is what I have always done, but it takes more time than melting the powder method. MonkeyWrench does the melt method and his research is completed in 35-40 minutes.

 

C

ChemMan

New member

• Nov 14, 2013

• #5

you can just mix in BA and BB mixture first and after add oil- in this way it would melt easily without excessive heating

 

THE 67

New member

• Nov 11, 2014

• #6

it this for every compound chemman or for just test prop ????

 

Powderguy

MuscleChemistry Registered Member

• Nov 13, 2014

• #7

I heat my oil in every experiment. It :
1. sterilizes the oil even further
2. makes the solution soluble and easier to work
3. filtration is easier without titration

If you heat anything and worry about degradation just heat the carrier.

 

THE 67

New member

• Nov 13, 2014

• #8

ive always have done it by heating my raw solution to half of the melting point and then raise the heat when adding the carrier and bring it up to 100c for filtration.