DEIMOS
New member
First thanks to IRONJULIUS for the invite here. Told me there were some good brewers here that might could help.
I have been brewing for over 10 years and do a pretty good job of it according to my local gym rats
I popped my cherry on Tren Base recently and it was an ugly event. Here's my recipe and how it went down.......
34.31 ml EO
3.75gr raw powder
1.50 BA
11.00 BB
~ 50ml @ 75mg
I heated powder to determine melting point which was around 94-97c
added pre-heated BA and BB stirred until clear
Added pre-heated EO and continued stirring until dark clear gold
filtered through a 0.22um PVDF filter then vialed.
It turned out just like a suspension. The powder clearly separated and fell out. No heating would put it back into solution.
Now i have 2 hunches but unsure.............
could I have had water in my collection container or was the PVDF filter wrong? I have never used this type of filter before but the limited resources I found all said because of the EO to use this type of filter.
Everything looked great up until the filter step so I'm kinda honing in on this area. Any ideas or suggestions would be greatly appreciated.
Thanks
I have been brewing for over 10 years and do a pretty good job of it according to my local gym rats
I popped my cherry on Tren Base recently and it was an ugly event. Here's my recipe and how it went down.......
34.31 ml EO
3.75gr raw powder
1.50 BA
11.00 BB
~ 50ml @ 75mg
I heated powder to determine melting point which was around 94-97c
added pre-heated BA and BB stirred until clear
Added pre-heated EO and continued stirring until dark clear gold
filtered through a 0.22um PVDF filter then vialed.
It turned out just like a suspension. The powder clearly separated and fell out. No heating would put it back into solution.
Now i have 2 hunches but unsure.............
could I have had water in my collection container or was the PVDF filter wrong? I have never used this type of filter before but the limited resources I found all said because of the EO to use this type of filter.
Everything looked great up until the filter step so I'm kinda honing in on this area. Any ideas or suggestions would be greatly appreciated.
Thanks