Ok heres another ?

D

dreamcatcher

New member

• Dec 22, 2003

• #1

I knew i forgot something in the first thread, I got a fina kit and keep the bottle at about room temp, but when I load , I take hot water from a coffee maker and heat the bottle so it will load and unload easy. whats your thought on this? seams to work good but does it hurt the fina?

 

saturn

New member

• Dec 22, 2003

• #2

I know a lot of poeple that run warm water over the loded syringe before injecting. They seem to think it helps but I don't do it. I don't notice much difference either way. I may be easier to push the warm oil through the pin and help the oil dissapate after injection. To much work for me. I'm lazy.

 

B

BiggerStronger

Member

• Dec 22, 2003

• #3

saturn said:

I know a lot of poeple that run warm water over the loded syringe before injecting. They seem to think it helps but I don't do it. I don't notice much difference either way. I may be easier to push the warm oil through the pin and help the oil dissapate after injection. To much work for me. I'm lazy.

Click to expand...

lol...true. I don't think it really helps that much. Just roll the syringe in your hand about 15-20 times to warm it up a bit.

 

rugbythug

New member

• Dec 22, 2003

• #4

Fina doesn't hurt anyway-Mine went in like butter. When I shot QV Ethenate I would warm it but that was like shooting gasoline.

 

jaywooly

Guru

• Dec 22, 2003

• #5

Yeah, that QV enanthate hurts like a bitch. I also don't warm up the gear when shooting. Lazy may be a factor with me as well.

 

mark mcgwire

New member

• Dec 22, 2003

• #6

I've never really noticed any difference either. I've run the syringe under hot water but it didn't really change anything.

I also don't want to make a project out of taking shots either.