Has anyone had a bad reaction to high dose gear?

GiantRack

New member
Had some test e 500 mg/ml
& Eq 450 mg/ml
Pinned 4 mils over 2 days to get started. Went and trained hard and went home. That evening and for 3 days after had very hard, sore & painfull muscles at pin sites. Quads were useless for 72hrs. Anyone have any theories as to what may have been the cause. I think maybe the work out was too much for the quad pin sites being very fresh and such high dose i.e. (a lot of hormone w/ very little oil). Maybe the lactic acid had something to do with it?

Your input would be greatly appreciated. Thanks in advance Bro's
 
GiantRack,

I am going to move this to the proper forum for you. You will get a lot more information there.
 
GiantRack,

I am going to move this to the proper forum for you. You will get a lot more information there.

High dosed gear can make me sore bad for a few days esp when I just start cycle or BLAST.
But after about 7 days to 10 I get adjusted to it.

Some gear just hurts depending of what it is made of and if my muscles had it before.
Alot of times it's just immune response and body doesn't cause inflammation after a week or so.

Also technique draw it warm it up in hot running water without wetting pin just body of syringe.
Relax use proper areas. Inject slowly. It takes me I good minute and a half to pin 3ml. And I breath in and out relaxing during.
If u push too fast it can be pressure to the muscle!!!
 
Had some test e 500 mg/ml
& Eq 450 mg/ml
Pinned 4 mils over 2 days to get started. Went and trained hard and went home. That evening and for 3 days after had very hard, sore & painfull muscles at pin sites. Quads were useless for 72hrs. Anyone have any theories as to what may have been the cause. I think maybe the work out was too much for the quad pin sites being very fresh and such high dose i.e. (a lot of hormone w/ very little oil). Maybe the lactic acid had something to do with it?

Your input would be greatly appreciated. Thanks in advance Bro's

High dose gear usually has a lot of benzyl alcohol/solvent in it to help keep the gear in solution, and this is what causes the pain. I had some 400mg/ml testosterone once, and damn, did that stuff hurt. I remember putting 1 ml in my arms, and one arm got so sore that I almost couldn't get the pain down with OTC pain relievers. The pain was definitely much worse when I worked the muscle that I had injected, probably because it helped spread the gear through the muscle.
 
High dosed gear can make me sore bad for a few days esp when I just start cycle or BLAST.
But after about 7 days to 10 I get adjusted to it.

Some gear just hurts depending of what it is made of and if my muscles had it before.
Alot of times it's just immune response and body doesn't cause inflammation after a week or so.

Also technique draw it warm it up in hot running water without wetting pin just body of syringe.
Relax use proper areas. Inject slowly. It takes me I good minute and a half to pin 3ml. And I breath in and out relaxing during.
If u push too fast it can be pressure to the muscle!!!

Great info, I agree with the immune response hypothesis.
I really do hope the pip subsides. There are some good pointers here and I will def. implement them. Thank you for the advice .
 
High dose gear usually has a lot of benzyl alcohol/solvent in it to help keep the gear in solution, and this is what causes the pain. I had some 400mg/ml testosterone once, and damn, did that stuff hurt. I remember putting 1 ml in my arms, and one arm got so sore that I almost couldn't get the pain down with OTC pain relievers. The pain was definitely much worse when I worked the muscle that I had injected, probably because it helped spread the gear through the muscle.

Yeah, that's pretty much where this heat put me. Glad when it went down. I repinned this week but put each one ina separate pin to find out which hormone is the culprit.

The eq is more than likely the primary cause. The sites are very tender, and painful
The test e pin sites are pretty normal.

Thank you for the help.
 
Back
Top