Thanks Thanks:  0
Recommend Recommend:  0
  1. #1
    Presser's Avatar
    Join Date
    May 2002
    Posts
    39,429
    M-Chem Coin = $1
    266
    Rep Power
    2147523096

    Default Getting back into the swing of things once this corona virus pandemic subsides and how to do get there faster by Front-loading your gear to get to peak levels faster

    Getting back into the swing of things once this corona virus pandemic subsides and how to do get there faster by Front-loading your gear to get to peak levels faster

    A: It’s not unusual, when not frontloading (taking a calculated, especially high dose on the first day), for results to be minimal or difficult to detect in the first couple of weeks and even to some degree into the third week. This is particularly so with especially long-acting esters.
    Another factor is that rate of muscle gain isn’t as high when starting from a higher level. I’m assuming that this cycle isn’t having you start at the same level of muscle as your first cycle did.

    Some drugs have relatively long half-lives, this being a measure of how quickly the drug leaves the system.
    When such a drug is being used, then the amount in the system at any given time is not only that resulting from the dose just taken, but also a further amount that is remaining from previous doses.
    So, using a steroid cycle as an example, suppose someone is dosing 100 mg/day of a steroid which has a half-life of one week, and over the long term this is giving him the levels he wants.
    Once well into his cycle, after any given injection he will have in his system not only the 100 mg that he just injected, but another 700 mg (one half-life’s worth) remaining from previous injections.

    So clearly, if on Day 1 all he does is inject 100 mg, he won’t have nearly the levels that his cycle, over time, will eventually produce. He would need to inject 800 mg to be in a comparable place.
    Frontloading is the practice where a calculated larger injection amount is used on Day 1 to promptly bring levels to the same value that they would eventually stabilize at.

    The amount to use is the amount that is on average taken in one half-life of the drug, plus the injection amount that will ordinarily be used.
    So for another example, let’s say someone is planning on using 600 mg/week of testosterone enanthate, taken as 200 mg three times per week.
    If figuring the half-life at 5 days, then on average the amount taken per half-life (per 5 days) is 5/7 of the 600 mg. That works out to an average of 429 mg taken per 5 days.

    So the frontload amount is that amount, plus the usual ongoing amount of 200 mg.
    If being highly exact this would work out as 629 mg, but as 600 mg is a more convenient figure, this would be more than close enough. There’s no problem in rounding the number a little.

    So on Day 1 the injection would be 600 mg. This would not produce unusually high levels, but instead would promptly get levels to where they need to be.

    If not frontloading but just doing the 200 mg 3x/week schedule, even at the end of two weeks levels would still be building. Only by the 3 week point (approximately) would they be nearly to their steady-state value — the value where they will or would eventually stabilize.
    Equipoise has a particularly long half-life and so if there is no frontload, it takes even longer for levels to build. This is why many say that it takes 6 weeks, or some similar figure, for it to anything.
    Actually the boldenone is capable of contributing well by the end of the first week, if the levels are there, but in the situations being referred to levels are not there due to lack of frontload.

    Another great resource on this and probably better explained can be found below:

    Frontloading with Testosterone cycle
    Author: Ben Presser
    Ph.D. P.E.D. Kinesiology
    Intramuscular Injection Certified

  2. #2
    MuscleChemistry Vet Board Certified Psy.D

    Join Date
    Sep 2014
    Location
    PUNJAB
    Posts
    300
    M-Chem Coin = $1
    6
    Rep Power
    2147483955

    Default

    Good read there presser
     

  3. #3
    Presser's Avatar
    Join Date
    May 2002
    Posts
    39,429
    M-Chem Coin = $1
    266
    Rep Power
    2147523096

    Default

    Thnx brutha!
    Author: Ben Presser
    Ph.D. P.E.D. Kinesiology
    Intramuscular Injection Certified

  4. #4
    MuscleChemistry Guru Board Certified CPH
    Boomer's Avatar
    Join Date
    Apr 2010
    Location
    Sydney Australia
    Posts
    1,038
    M-Chem Coin = $1
    20
    Rep Power
    1089963

    Default

    After trying front loading once I have never gone back.
    It does work
    Likes Presser liked this post
     
    C'mon!.. give me two more! .. lets get serious!"

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in

Log in