Recommend: 0
-
08-06-2019, 08:16 PM #1
- Join Date
- Nov 2018
- Location
- Most likely at the gym
- Posts
- 71
- Rep Power
- 183
Masteron enanthate aka drostanolone enanthate's melting point???
I am finding melting points from 65 to 235 degrees Celsius. Does anyone know?
Does anyone know masteron enanthate's melting point?jimbosmith316 thanked for this postjimbosmith316 liked this post
-
08-06-2019, 08:32 PM #2
-
08-07-2019, 08:28 PM #3
- Join Date
- Nov 2018
- Location
- Most likely at the gym
- Posts
- 71
- Rep Power
- 183
Yeah I found that one too, another raw supplier had it at 235-238 degrees or so. Then another site I found after I posted had it at 50-58 degrees.
It's all over the place. When I compare melt points that I know to be true with other hormone melt points on these sites the other hormones have the correct melt points so it seems it only the mast enanthate they can not agree on.
-
08-07-2019, 08:38 PM #4
- Join Date
- Nov 2018
- Location
- Most likely at the gym
- Posts
- 71
- Rep Power
- 183
I am starting to think that I should just start at room temp then go 2-3 degrees at a time and slowly ramp up. Then whatever it melts at I just write it down and then find some sort of reactive test to see if I can verify that the powder I have comes back as mast enanthate. Only problem with that is that won't show me how pure it is. Where as any other hormone I melt test and compare to the known melting point I can use that as a way to see if there are any cutting agents in the powder that is if they don't go and find a special cutting agents with the same melt point as each individual hormone. Somehow I think doing all that would end up being more expensive than just sending out un diluted raw powder.
So if anyone has had mast enanthate raw powder and gone through this and somehow verified the melting point then please share. Otherwise I am stabbing in the dark and hoping that what I have is properly labeled and un diluted, that is not how I like to inject.jimbosmith316 thanked for this postjimbosmith316 liked this post