1. #1
    MuscleChemistry Newbie Board Certified Psy.D

    Join Date
    Nov 2018
    Location
    Most likely at the gym
    Posts
    71
    Rep Power
    183

    Default Masteron enanthate aka drostanolone enanthate's melting point???

    I am finding melting points from 65 to 235 degrees Celsius. Does anyone know?

    Does anyone know masteron enanthate's melting point?
    Thanks jimbosmith316 thanked for this post
    Likes jimbosmith316 liked this post
     

  2. #2
    MuscleChemistry Board Certified MD
    jimbosmith316's Avatar
    Join Date
    Apr 2014
    Location
    Georgia
    Posts
    2,451
    Rep Power
    2147486108

    Default

    I found this

    Sent from my SM-N950U using Tapatalk
     

  3. #3
    MuscleChemistry Newbie Board Certified Psy.D

    Join Date
    Nov 2018
    Location
    Most likely at the gym
    Posts
    71
    Rep Power
    183

    Default

    Yeah I found that one too, another raw supplier had it at 235-238 degrees or so. Then another site I found after I posted had it at 50-58 degrees.

    It's all over the place. When I compare melt points that I know to be true with other hormone melt points on these sites the other hormones have the correct melt points so it seems it only the mast enanthate they can not agree on.
     

  4. #4
    MuscleChemistry Newbie Board Certified Psy.D

    Join Date
    Nov 2018
    Location
    Most likely at the gym
    Posts
    71
    Rep Power
    183

    Default

    I am starting to think that I should just start at room temp then go 2-3 degrees at a time and slowly ramp up. Then whatever it melts at I just write it down and then find some sort of reactive test to see if I can verify that the powder I have comes back as mast enanthate. Only problem with that is that won't show me how pure it is. Where as any other hormone I melt test and compare to the known melting point I can use that as a way to see if there are any cutting agents in the powder that is if they don't go and find a special cutting agents with the same melt point as each individual hormone. Somehow I think doing all that would end up being more expensive than just sending out un diluted raw powder.

    So if anyone has had mast enanthate raw powder and gone through this and somehow verified the melting point then please share. Otherwise I am stabbing in the dark and hoping that what I have is properly labeled and un diluted, that is not how I like to inject.
    Thanks jimbosmith316 thanked for this post
    Likes jimbosmith316 liked this post
     

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in

Log in