I have studied enough about injecting to be comfortable with it. The only problem is that all of the information I've found says "pierce the top of the amp with the needle and inject the appropriate amount of air into the amp".
What about if your using an amp that doesn't have the piercable rubber? Do you just snap it off, stick the pin down there and try to draw it up? Does this type of amp leave you susceptible to drawing more air into the syringe?
Any hints, tips, or advice on dealing with these amps would be greatly appreciated.
Thanks
What about if your using an amp that doesn't have the piercable rubber? Do you just snap it off, stick the pin down there and try to draw it up? Does this type of amp leave you susceptible to drawing more air into the syringe?
Any hints, tips, or advice on dealing with these amps would be greatly appreciated.
Thanks