Search results

BW2

GHRP-2 100mcg and mod 1-29 100mcg makes me hungry. Not like 6 but I deft have to use ipam if I don't want to eat. Took me a long time to figure it out cause everyone says "GHRP 2 doesn't induce hunger" well that's just not true for me.

At certain times I get a sweet craving I down a couple Quest bars. Cookies n cream. Another thing u can do cause u mentioned u mow down some ice cream is get yourself a thing of Hagen Das vanilla yogurt and a box of double chocolate quest bars. Put one bar in the microwave on "soften"or "melt"...

Anyone? I really am considering his cycle for several reasons easy on hair, I need to start TRT anyway, don't want acne, don't want to puff up but rather get some lean gains and get motivated to be in the gym more. I know tren is the answer to the gym more part and lean gains but I also have to...

Well we certainly hope he's still around and figured out his homebrew ;)

Anyone here run this or something close? I have all the supplies to do this and am seriously considering it as I value my hair and have terrible time with acne. I was considering EOD pins because hell, how is one gonna get 800mg of 100mg primo in one pin anyway (plus the one CC of t, your...

Amorse, not sure if trauma is still around a decade later ;)

He started on test e once every 10d IM with adex EOD and then we changed him to e3d test e with same dose per week but subQ and dropped the adex and now he has actually just switched to prop EOD sub q with the same mg dose adjusted for the less ester. He feels like a kid again. He's 65. I have...

OP, the deal here is if you do say 200 of long ester in one pin you will have way more issues than if you break that up into ED injections of 28mg. Then if you use a shorter ester like prop you will drop the need for a AI even further. My father went to EOD injections from his dr prescribed once...

I honestly didnt personally use the gear even after it has been re filtered after the melted filter. I could never get the oil as clear as a non- melted filter batch and that means to me that although there was no bacteria and the product was sterile there was still "durapore" PVDF clouding it...

Dilute to 150 and some good heat and it should hold

OP. I read your contest prep thread so I would say T3 with the gear u are on since it will eliminate muscle wasting(if this question is for you) The other alternative that hasn't been mentioned is Albuterol. It has actually been shown to increase muscle in some studies.

At 200/? Yea it will. Try diluting to 150/ and u should be ok with the higher bb. If you have more powder the easiest way to dilute is to make a equal batch at 100/ and swirl/heat together with the 200/ and refilter(leaves you with 150/). You should clear up all that cloudiness as well if you do...

no. 2/18/GSO is short for 2% BA/18% BB/GrapeSeedOil. InHg is inches of vacuum. Too much and you will suck the filter membrane out of its holder (pretty obvious)or worse get a tear in it and not know it and your entire media flask will be compromised.

Wow. Same issues I had. I had to sort it out on my own though. Took me a lot of testing, hours and about 6 stericups. Ok here are the facts: 1. Make sure oil cools to below 130deg f before pouring into funnel(top of stericup) yes. 180deg melts the filter membrane and causes cloudy, contaminated...

Asphyx, I had the exact same issue with what appears to be the same setup filter ect...tell us what temp the oil was when it was dumped into the funnel(top of the stericup) and what hg of vacuum you had on the cup.

Glassware should be alcohol rinsed and then dry heat sterilization of 2hrs at 340 deg F. No need for a autoclave to sterilize new glass.

Noted CS, but I was trying to kill two birds here and cut a little BF before I start my cycle. I have cut from 24%to 14% slowly by diet and training in the last 12 months and want to be at 12% before I start aas. I still can't see my abs!