Got a question about mixing oil & water based injectables

Pumping Iron

New member
I figured i would ask everyone's opinion on this.

Is it ok to mix QV winny and QV prop into the same pin ?

Should i pull the prop first then pull the winny and heat the syriange under hot water to try and mix the two together then inject it?
 
It's no problem to mix oil and water based in the same syringe, some people will disagree with me, but I've done it before works fine.

It doesn't have to mix to inject.
 
yea i got the same answer from wierdAl so i figured it was ok to do it.

So you haven't had any problems with abceses or any infections?

Do u think the winny will cut down on the pain of the prop?

Thanks
 
I hate to say this but I used winny for 1 cycle only-It was that painful itself! It is actualy crystals that are not completely dissolved in the water base............
 
BLEED GREEN said:
I hate to say this but I used winny for 1 cycle only-It was that painful itself! It is actualy crystals that are not completely dissolved in the water base............


so im in for a real threat :(
 
mine wasn't too bad, I've never used QV, but I've heard that their stuff isn't too painful.
 
I always mix QV prop and QV win. The oil in the syringe makes the win easier to pass through. I hit my shoulders with 1 cc of each of these every other day. I don't find it ti hurt. No problems with mixing oil and water at all. Just shake the syringe up once you load it so it goes n easily. Been doing it like this for 12 years.
 
I have been mixing Tren, QV Prop and QV winny for about 3 weeks and have not had any problems. A little sore sometimes but goes away. I always draw the oil and then the winny. the winny is somewhat suspended in the oil.
 
It's great to see you guys have actually used the QV winny with the QV prop which i will be using and trying the mixing.

Today is my first day :D


What type of results have you guys gotten on QV winny and QV prop, am I in for a nice threat :D
 
The only problems I see is you have to keep the same constant pressure on the syringe while injecting. You don't want to be applying a lot of pressure with the oil and then hit the water based and have a huge surge being injected. You know what I mean?
 
MacGyver said:
The only problems I see is you have to keep the same constant pressure on the syringe while injecting. You don't want to be applying a lot of pressure with the oil and then hit the water based and have a huge surge being injected. You know what I mean?

yea i see what you mean, but the water base will be going in first before the oil.


so when it gets to the oil it will be slower, no?
 
I was mixing Winny and Deca in the same pin...no problems. I only did glutes with this and then had my wife do most of the injections. When I did it myself I found it hard to keep consistant pressure and usually ended up more sore than when she did it.
 
Back
Top