heating enth?

I have question..

I mixed up a batch of enth 6 days ago and before I had time to bottle, I was called away on emergency. I put plastic wrap over top of beaker and made extra sure it was sealed well before I left.

Now 6 days pass.. I want to put the enth into vials, then into me

Should I heat the oil/enth mixture say for 30 minutes at 225 degrees to sterilize the oil. Or do you think its good to go with the ba/bb already in the mixture..

Personally, I think it is fine but I like to do final sterilizing procedure before I bottle..

Any suggestions????????????????

Should I heat the mixture? Should I add a bit more ba? Should I add a bit more ba and heat mixture?

What is maximum temperature you can heat enth before you effect the potency?

Thanks in advance!

Bottle and stick your fine the way it is.

it should be fine if you took the care to make sure the beaker was sealed well if you feel like it you can heat it that will make it flow a little eaiser when transfering it to smaller vials

good luck !

did you filter? if not i would filter it first...i like to heat my products right before filtering.

i just bottled it..

I did seal it very well, used 3 layers of plastic wrap tight to beaker top..

I was going to heat, but was thinking because of enths low melting point, might damage potency if heated even to 250?

anyways.. all done

did you ever filter it?

Let us know how it works out Iron Bro..

Why did you put BB in the mix..I never add it to enanthate, the less solvent in my body the better. Just my method bro....

well. so far so good.. pretty painless too (ya I filtered it before I left)

I use 1.5% ba and 8%bb

the bb i just use to thin the solution so you are able to use 25g.