paperbolix
New member
I wanna make some test prop, the only problem is the recipe calls for 15% BB and 5% BA, but I only have enough BB for 10%, can I do 10%BB and 10%BA or will that screw it up?
BA vs BB
- Thread starter paperbolix
- Start date
BiggerStronger
Member
it will probably sting like a mutha, but sure it would work.
brew
New member
WHOA, hold on a minute. your shoot 10% ba and your going to be crippled. I had fina at 7 % before and it wounded me pretty bad, lol. There is no need for more than 3% ba abd 9 BB, and that high to me. I use 2.5 and 7.5 for 100mg/ml, hold fine and completely painless. Use the pwder calc stick at the top of this forum to figure out your amounts of solvent, oil and powders, its real handy.
brew
New member
Yeah, I was just trying to save him from gimping around for a months straight, I couldn't straighten my bis after that fina for two days. FYI paperbolix ba is 3 times as effective as a solvent as bb, so if you were trying to make up for a 5% difference in bb it would only take 1.75% ba to equal the 5%bb you were lascking. Make sense?
paperbolix
New member
so its the increase in BA that causes the pain, not the lack of BB..what if I just used 10%bb and left the BA at 5%?
Crimsonsweat
New member
it depends on how much volume your doing to, 10grams 20 grams 5 grams? so that will help to determine a ratio you need. i never add bb unles i have a high mg/ml ratio then the ba comes down and the bb goes up.
TP over 100mg or at will only need 2-2.8 max of ba for test prop. keep it clean get good supplies and it will be all good.
if you do add more ba and bb the dont exceed 10% total volume for 100mls of ba and bb good rule of thumb even at that might sting a bit but still remain comfortable.
TP over 100mg or at will only need 2-2.8 max of ba for test prop. keep it clean get good supplies and it will be all good.
if you do add more ba and bb the dont exceed 10% total volume for 100mls of ba and bb good rule of thumb even at that might sting a bit but still remain comfortable.
EatingMachine
New member
The higher the quality of the hormone, the less overall solvent will be required as well.
BB does ease pain to some degree because it is slow to dissapate from the injection site, keeping the hormone from sitting right on the muscle tissue.
I've successfully taken a horribly painful solution to tolerable by merely adding bb.
BB does ease pain to some degree because it is slow to dissapate from the injection site, keeping the hormone from sitting right on the muscle tissue.
I've successfully taken a horribly painful solution to tolerable by merely adding bb.
