Preloading pinz

I was wondering if anyone preloads thier pinz. I will be starting my next cycle and using 4 different types of gear. All are oil based and total 3ml / 2 times a week. I was wanting to know if it was acceptable to sit down and load 2 or 3 weeks worth of gear into pinz and let them sit. I would be drawing the oils with 1 pin and then removing the plungers of the pinz I want to load. when I am finished I will replace the plungers and have 6 or 8 fully loaded pinz ready to go. All I would have to do is replace the 18gauge needle with the 22gauge needle when it is time to inject and then do the injection. Any comments either way are welcome. I will be using sterile surgical gloves and taking precautions as to not contaminate the oils while I am loading them. Like I said I am only considering this It is not set in stone ...yet. Just want some feed back.

Thnx

Pre loading can save a lot of time and as long as you keep everything clean you will be fine. Don't think you really need surgical gloves, but I guess you can never be too safe. Draw the gear up, swap the pins and store in a safe place. Nothin to it.

Bizumpin' MACE!! You just need to make sure you keep it in a sterile area at all times so you don't let the gear become infected with something... & turn around & pass it to yourself..

I do it to save putting holes in large vials.....I get 1/2 thru a 50 and there is rubber floating in the oil, when I load a wks worth at once, much less rubber in my gear.

Thanks for the response guys. I will be loading the pinz today.

i have seen guys pre load an entire cycle and have no problems...i dont have enough balls to do that. I will do maybe two or three days worth but no more

So brew, would u then have to toss the gear once u got some rubber in there?

It would just suck cause sometimes you'd draw up a peice with the 18g. Its big enough to not go out the 23 but it would settle to the bottom and clog the pin sometimes. Had a few I just re-filtered the whole vial to get it out cuase that kept happening way to often. Now I jsut leave the 18 g in the top and use that single pin to fill like 8-10 at a time so its less holes.

I never have preloaded. Heard only good things, I guess I just have too much time on my hands..

Cool brew. I ask cause I got an 80cc vial and some 50cc ones and draw ED. I draw with a 23g though.

I dont preload b/c i am always worried bout sterility issues buti also have the time to load each every time.

da_Fonz said:

I dont preload b/c i am always worried bout sterility issues buti also have the time to load each every time.

Click to expand...

I used to be the same way, but I bought a small organizer and keep the preloaded syringes in there. It closes tight and nothing touches the syringes that's not clean and sterile. I make sure to clean everything and touch nothing other than the vials, pins, cotton balls, and alcohol. I wipe everything down prior to preloading even the entire outside of the alcohol bottle because I may have touched it for other reasons throughout the week. I never touch my face or any other part of my body during the process. I turn all fans off and make sure the area is wiped down with cotton balls and alcohol. I even started preloading my GH, HCG, adequan, and B12. Obviously the GH and HCG are mixed and preloaded differently due to their volatility after being reconstituted.