diluiting test 400

hey guys i have some test 400 not planning on starting right now but a buddy of mine had the same shit from same lab and everything and it damn near nocked his shoulder and ass off when injected lol. no infection or anything just notted up really bad and was too damn sore he said for like a week at a time. any ideas on how to make this better bacteriostatic water?? i wanna use it if i can but def. dont wanna go through what he did thanks bros.

shoot a smaller injection
try to do 2 -1/2cc injections instead of a whole one

he did that once and said it still hurt like shit i guess the toxicity is the same 1/2 cc is still the same as 1cc 400 i guess i dont know how bout the water thing has anybody ever tinkered with this. thanks for promt reply superman

no problem Gbart

i had to buy a masseger once because i was all knotted up from something i was taking

Using BW is not a good idea. Get your self some sterile oil (grapeseed is my choice) and some BB. I would make the oil to have about a 15% bb content. Mix the two solutions by doubling the volume, leaving you with something around 200mg/ml, which should be a peice of cake.

do i put the oil directly into the test or in a seperate vial then draw from each sorry brew im very new to this lol all i ever know is buy it and use it haha.

Can't use the water because oil and water don't mix. Get yourself a new sterile vial that can contain both and mix them together.

do i just draw from the oil and shoot it in the other vial same as the test as i said everything like this is very new to me

No, you have to mix the oil with BB first. Brew can tell you the exact process for this. Have a new vial that is big enough to hold the volume of both and a top to crimp on it ready when you do this because after you make the oil to cut into your test, you'll put them together into the new vial and crimp a new top on it (all done under sterile conditions of course). There is a little process to doing all this so perhaps some of you bros who have done this before may want to pm him with some info or post it here.

k thanks tony

ok bro you need sterile oil, a whatman .45 filter, a little ba and soem 18g pins and a new sealed sterile vial. If you got 10ml vial of test then you need a 20ml new vial. Take 10ml of your oil and sterilize it. You can do this by baking at 225-250 for an hr or so, or you can add 3%ba and that will do the trick. I would opt for the ba and filter. draw up .3ml of ba, 1.5ml of bb and 8.2ml of oil. Now filter this into the already sealed sterile vial. Make sure you wipe the top of the vial ith and alcohol pad so that you don't drag any contaminants into the vial. Then draw up 10 cc of the test and filter that into the sealed vial as well. If you can get a 20cc syringe then you can do both at the same time. I would swirl this well for some time before using, mild heat will help get uniform distrubution quicker as well. Make a warm water bath with 1 in of water on the stove with low heat and swirl it every 5 min for like and hr or so and tat should do it.

let me guess. its denkall's t-4. that shit was brutal. i have never felt pain like that in my life. you know what else you can try is mixing it with like some deca or something like that in the pin. i would draw 1 cc of the t4 and 1cc of deca and it didnt hurt that bad at all

its an ug lab down here but yes i hear its very very painful.