water in trenbolone

cbigswole05

cbigswole05

New member
didnt have any pins so i decided to sterilize a few by boiling them. i went to draw out some homebrew tren and noticed a few drops of water in the syringe and in the bottle of tren. what should i do? i know i shouldnt reuse pins but i didnt have access to new ones. i have about 15ml left and dont want to waste it! plese help!!!!
 
no its not illegal its just a bitch trying to get them when you are 6ft tall and 265. the question is what should i do about the water thats in the tren?
 
did you at least use distilled water? injecting water isn't going to hurt as long as water is sterile, winstrol depot is water based..your asking if it's ok to not be a safe as you possibly can and to re-use needles-it's not recomended but only you can decide
 
If you boiled the pins, the water that dripped in won't have any bugs in it, so you are fine. You can even mix an oil based and a water based AAS in the same pin (but I would never recommend it because you have to push hard to get the oil through and then you hit the water and it shoots in fast as hell).

You didn't do anything unsafe in boiling the pins (assuming the plastic didn't melt...). But they are made for one use and get pretty dull, pretty fast. I use a 20g pin to draw and a 23 g pin to inject so the pin isn't dull. So basically it feels a whole lot better than what you are doing.

Just order in bulk at getpinz next time and save the hassle.
 
doctorwill said:
If you boiled the pins, the water that dripped in won't have any bugs in it, so you are fine. You can even mix an oil based and a water based AAS in the same pin (but I would never recommend it because you have to push hard to get the oil through and then you hit the water and it shoots in fast as hell).

You didn't do anything unsafe in boiling the pins (assuming the plastic didn't melt...). But they are made for one use and get pretty dull, pretty fast. I use a 20g pin to draw and a 23 g pin to inject so the pin isn't dull. So basically it feels a whole lot better than what you are doing.

Just order in bulk at getpinz next time and save the hassle.
Click to expand...


the water that seeps into the pin may or may not be sterile. I wouldn't risk it...
the water could have seeped in before it reached the boiling point and you would need to boil it for long enough to make sure the temperature stayed high enough to kill all the harmful bacteria
 
So you're assuming that he didn't wait until it boiled to drop them in?

And, I thought it WAS indeed illegal to buy pins in TX.
 
Never occured to me that he would put the pins in before the water was boiling. However, if the water oustide the pins boiled, the small amount of water in the pin should be hot enough as well. Of course you need to let it boil for a bit.

Couldn't he stick a pin in the top (not in the liquid) and bake if for 25 minutes at 275 or so and that should take care of it. If he is really concerned, add a quarter cc of BA and then re-filter it.

Obviously, re-using the pins is not the best course of action.
 
If you want to re-use pins (which I would really recomend against, ever seen a full blown abcess??) after inject pull in 3cc of alcohol, place the cap back over the pin the push the alcohol out enough to fill the cap & store 'till next use (still a bad idea but it works in a pinch). As far as the water in your tren, stick an 18 gage pin (with no syringe attached) through the stopper, not far enough to reach the tren, place on a cookie pan in the oven at 250 degrees for 20 min. this will boil off any water in the tren and steralize the tren. Make sure your oven is accurate at 250 degrees.
Like mikeswift said though, best to plan ahead, keep a case of pins on hand (getpinz.com)
 
jaywooly said:
And, I thought it WAS indeed illegal to buy pins in TX.
Click to expand...

As most states....illegal to BUY, legal to have. So stupid I know.

Its like being able to buy a gun, but no bullets.
 
You must log in or register to reply here.

Similar threads

Presser
Compounding Trenbolone Acetate Powder into an Injectable: A Comprehensive Guide
Replies
0
Views
396
Presser
Presser
Muscle Insider
Water Fasting: What is It and is It Safe?
Replies
0
Views
389
Muscle Insider
Muscle Insider
Muscle Insider
Peptide Reconstitution + Mixing Guide with Calculator Copy
Replies
0
Views
102
Muscle Insider
Muscle Insider
Muscle Insider
How to Reconstitute Peptides
Replies
0
Views
109
Muscle Insider
Muscle Insider
Muscle Insider
Kali Muscle Says Steroids ‘A Waste of Time, ‘I’m a Natty Right Now, My Testosterone Level is 280’
Replies
0
Views
104
Muscle Insider
Muscle Insider
Back
Top