I start my igf next week and have been reading enough about measuring on a slin pin to make my head spin. I keep getting contradicting answers. SO!, since i have the mc igf (1000mcg), 30gauge/.5"/1mL pins.....and the marks go 10-20-30...100 with 4 little ticks between each of them. Does one little tick equal 20mcg?? I know this has been said again and again, but I dont want to F this up, thanks guys.
IGF measurement q
- Thread starter jmacey22
- Start date
Get_Swole
MuscleChemistry Registered Member
1 tic mark on a .5 cc slin pin should be 10 mcg's so in turn if your gonna run 40 a day broke down to 20 twice you would run 2 tics twice a day this is how i ran it and i checked measurements numerous times hit the search button under igf measurement you should see some of my posts if you wanna be absolutely sure.
S
saudades
Guest
He has a 1 cc slin pin, and on 1 cc pins, 1 tick is 20 mcg according to the 1000 mcg /1 ml dosage the IGF is prepared to. Both .5 cc and 1 cc slin pins are .5 inch long. I think that's where a lot of the confusion results.
Get_Swole
MuscleChemistry Registered Member
i ran it at 40 mcg's a day and hardened up nice and put some size on my arms i was very sensitive to it as i went hypo on it several times but everybody is different bro. From my knowledge thats usually the starting dose for most average people there are people on here that are far more advanced in it then me but i would say 40 your first time should yield pretty decent results especially if your running aas with it, or for pct. good luck bro and keep us posted.
S
saudades
Guest
Had great results with 40 mcg the first time around, and Gbart is right--that's the usual starting dosage as well. I went a little hypo the first time myself, but I must have become used to it because I haven't had that happen in subsequent cycles at higher dosages.
Similar threads
