Why, Why, Why

What in the world is going on. I can make everytype of gear and it comes out perfect. But when I make Tren A it is so cloudy it scares me. I just finished 50 mls @ 100 mgs and it looks like shit. I used grapeseed oil, 2% BA and 15% BB.

I bring water in a pan to a boil and turn it off. I put the BA, BB and the powder in that water bath for 15 min's. That the only heat except for the oil I heat up to 275 degrees for 30 min's.

I make all my gear the same way and it comes out clear as hell. This tren doesn't have swirls or if it does you can't see it because of the SMOG.

I've had it turn out like that when I use finnaplix.Never tried it with just powder.I know with the fina it was fine like that.I have never understood why it happened either.

oldtimer said:

I've had it turn out like that when I use finnaplix.Never tried it with just powder.I know with the fina it was fine like that.I have never understood why it happened either.

Click to expand...

I'm wondering if I got it to hot. All of a sudden it had small black particle and clogged up 2 filters doing the 50 ml's.....I use powder not the pellets

It may have been you got it to hot.But I'm not sure about the partcle's in it.Did you filter it again to make sure none got in the final product?

I doubt you got it hot enough to do any damage. I forget the exact melting point of Tren A but I beleive its around 90-05 C, could be wrong though. I have had a similiar problem before with tren. I have had crystal clear batches and then I have had darker batches. What it seems to come down to is the enviroment in which the powder was made and stored. Seems like in conditions of higher temp/humidity (summer) the product is darker, and then when its not exposed to this, it seems to be clearer, slightly darker than the oil is orginally. Now, as far as cloudyness, I would refilter just to be safe, and then I would use it regardless of the color.

Cloudy tren is from not having a good enough coffee filter using the pellets :fyi:
If you made it with powders,no binders to filter out. Little trick is let the bottle/vial sit for for a couple weeks. Lean it about a 30 somethin degree lean in a some folded up socks. Then just draw off the ba.bb.hormone. Leave that crap back in the bottle/vial as a clump in the bottem. Takes about two weeks. Also add would add more ba to your mix using pellets go to .035 at least,just cause, using pellets ba seams to disolve them better.my 02

Well I think I found the problem. The powder was garbage. I threw that shit out. This morning I opened a new pkg of tren Powder and made 50 ml's. Came out perfect. Clear as hell and not even a swirl. Made it the same way.

The other powder didn't look right and had little off color particles in it. This new pgk look all one color a light tan.