Hcg

GBQ59

New member
I'm about midway through my cycle now and I was told this is the best time to take hcg. I have 10,000iu of it and was wondering the correct way to break it down into how many injections, how often, and for how long, ways to inject it, etc. Its the kind where u have the vial of powder and the vial of solution and you have to mix the two together. I also heard u shouldn't take hcg for too long so thats why I want to find out the correct way b4 listening to the many methods I've heard. Ur input is always appreciated! Thanx
 
Man that was some of the greatest info I've gotten on this site...I got jus a few questions, how do I convert IU to cc or ml, also if I want to inject into the layer of fat what type of pin should I use? I got NOVA, PRO V, and CLOMID...I have been taking 25mg PROV and 10mg NOVA everyday since I started and will contiue it until the PCT is finished and the clomid I am taking rite after my cycle is finished. Thanx again!
 
GBQ59 said:
Man that was some of the greatest info I've gotten on this site...I got jus a few questions, how do I convert IU to cc or ml, also if I want to inject into the layer of fat what type of pin should I use? !

you should be injected hcg with a SLIN pin. You can inject in the muscle or the fat. i've always done the muscle cause everything else I inject goes there.

a cc and ml are the same thing...you probably know that and if ya didn't, you do now. IU's are actually determined by YOU, by how much BW you mix in the hcg powder in the vial.

do you have 2,000iu vial? or 5,000iu vial? let us know.
 
The box says 10,000 U 10 ml.....so i'm thinkin 1ml=1,000 IU but u can verify that...What is a SLIN pin? Thanx for the help, appreciate it!
 
GBQ59 said:
The box says 10,000 U 10 ml.....so i'm thinkin 1ml=1,000 IU but u can verify that...What is a SLIN pin? Thanx for the help, appreciate it!
ok, so its NOT mixed yet right?

Im assuming they put 10,000 units of HCG powder inside a 10ml sterile vial. Then you just add water.

If thats the case, then mix with 10ml of B.water and then you will have 1,000iu's per 1ml. If you want a higher dose, add less water and do the math.
 
Right it's not mixed yet.....Now if I did not want to inject in a pinch of fat with the slin pin, can I inject intramuscular with a 22g 1 1/2 in pin?and will it still work just as well? Thanx
 
GBQ59 said:
Right it's not mixed yet.....Now if I did not want to inject in a pinch of fat with the slin pin, can I inject intramuscular with a 22g 1 1/2 in pin?and will it still work just as well? Thanx

you could. But you can go IM with a slin pin also. I would recommend that over going IM with a full size pin. This is what I do. Slin pins = zero pain.

Water based products usually go through much smaller pins, so take advantage of that.
 
Slin pin for sure..........You lose alot in screw on part of the 22gauger unless you inject some air......enough to get all the fluid out. A tiny bit of air wont kill ya either.........But slin pin is painless and more efficient.
 
bump the slin pin posts... you'll have a lot more accurate measure and no pain. I've done HCG both IM and SubQ with a slin pin with no problems. Smooth
 
Yeah I hear what u guys are sayin, I'm gonna try and get some slin pins a.s.a.p., I am on track to take it within the next few days so if I can't get it by then I'll just use the 22 guages I have.....I'm gonna run 2500 iu once a week for two weeks and then should I run it again right at the end of my cycle or right after my cycle ends? Also I've heard that after it's mixed it should b refridgerated for it to last, can anyone provide some info on that also. Thanx!
 
Last edited:
Back
Top