synovex conversion report

This time around I did the synovex conversion without a kit. I used the saturated sodium hydroxide as the estrogen soulublizer. I added it in and let it set for about 30 minutes and then added the distilled water very slowly. I am positive I have test propionate, being that is the only test I ever use. It got rid of the estro very well being I have no estro sides and I am using 1.5cc eod with no estro blockers. I honestly believe that the esto solubilizer in the kits is saturated soduim hydroxide. I spent a lot of time looking into this so that I would not have to buy a kit or the expensive estro solubilizer and by george it worked and I am very pleased with it.

note: next time I do this using my own estro killer, I will not let the water drip in real slow. what happens is you are allowing the lye extra time to react with the test and it starts turning the crystals into a yellow sludge. I would add the water a lot faster doing it this way.

I just thought Id report this because I never could find a decent answer to this question. It drove me nuts for months until I just dove in and did the damn thing.

I have been going through the same thing. I purchased a huge container of the Naoh. I have yet to use it. How much did you disolve? in how much water? did you heat the water prior or did you use cold water. Please tell me i have to know. Do you have a whole recipe or do you use someone elses