IGF mixing ??

so i recieved my 2 bottles of MC Immense Growth Factor last week

after i finish my current cycle i was goin to start the 2 up. now i see that it comes in liquid form, not powder. Do i mix this liquid with anything, or do i take it as is ? Immense Growth Factor is one topic that i havent done alot of research on , so to this i am a complete newbie

jonflex said:

so i recieved my 2 bottles of MC igf last week

after i finish my current cycle i was goin to start the 2 up. now i see that it comes in liquid form, not powder. Do i mix this liquid with anything, or do i take it as is ? IGF is one topic that i havent done alot of rescearch on , so to this i am a complete newbie

Click to expand...

Dilution is an option, not a necessity. I have read where some insist that it is less irritating when diluted with BW. Also, some believe it helps spread the substance through increased volume. Anyway, as I have read, the BW is added to the measuring device after the Immense GF has been properly measured. In other words, they are not stored together. The amount of BW used is optional. After everything is together, simply divide the total number on your measuring device by 2 for bi-lateral rubbing.

It's called Immense Growth Factor

Regardless, it comes as a liquid and you should just apply it as is or if you have sterile water you can mix it in the same container and apply it in equal portions to avoid any irritation. Personally I find the amount is so small that it causes very little irritation if any at all. Way less than other products. I would just use it as it comes, but I do see how the more volume theory would work.

Well I found it a bit odd that there's only like 1 ML in a 10 ML vial of IGF. That answers my question, though. (There's 1000 micrograms (MCG's) in 1 milligram.) The only other question I have then is if there's only about 1 ML in the vial (and there's suppose to be 1000 MCG's in there), how do you measure out true MCG's using a slin syringe if there's only 1 ML instead of 10? I mean, if I have a slin pin that holds 100 U's, how much do I take out that would equal, let's say, 10 MCG's? I'm guessing just drop the "0" and take out 1 MCG, but what is that equal to in regards to the lines on a slin pin? (I'm new to this, too, and I'm learning from you guys... thanks again.)

thanks Vitalyguyvan, that was my next question........... and i only have 5 weeks to figure it out..... anyone can help

bump

each line on the syringe you multiply by 10 and that will give the amount of mcgs u have, so if ur filled to the 10, then you have 100mcgs, 20 = 200mcgs ect...

is that what u were aksing?