highest concentrations for EQ, deca, npp, tpp, etc.

Im looking to start making my gear as highly concentrated as possible without substantial increases in injection pain or possible crashing even with EO and 20+%BB. This is what I am thinking:
TEST E/C - 330 - 400
EQ - 400
Deca - 300-400
test phenylprop - 200
npp - 200
Any experiences with these concentrations? if so, what were you ratios?
thanks.

ill bump this bro as i have no idea myself

im sure if i use EO as the primary carrier i can hold tpp/npp at those concentrations. Im not worried about deca and eq at 300+ bc of the super low melting points. but test above 300 im not too sure and just cause the eq and deca would hold above 300, it might hurt like shit.

I have made test-e @ 500mg and a eq blend 200 eq prop and 400mg undec for a total of 600mg/50ml jugg 3.5%ba w/20%bb and EO. Both were pain free and smooth although did get a mild case of test flu. Also made a 200mg prop and injected into my pecs and had no pain at all! One of my props ended up crashing though I think it was cuz it was a 50ml jugg!?
This was like in 06-07 back in the good ol' days!:thumbsup:

detone01 said:

im sure if i use EO as the primary carrier i can hold tpp/npp at those concentrations. Im not worried about deca and eq at 300+ bc of the super low melting points. but test above 300 im not too sure and just cause the eq and deca would hold above 300, it might hurt like shit.

Click to expand...

I just made some Cyp 300, it's about a week old and holding fine so far. I don't know about the pain factor because I have not tried it yet.I used a 50-50 mix of EO and grape seed oil and I'm anxious to try it unfortunately the next cycle will be short esther's.