Hives from Mod GRF 1-29 (no DAC)

Hi All
I'm a 53 yo male with low T. I am on Dr prescribed cypionate at 200mg E5D. I have been taking peps to assist in anti-aging since Feb 12. About 3 months into the peps I began to get a hive at the injection site. I am taking GHRP2 and Mod GRF 1-29 (no DAC). I have tested 4 different suppliers with the same results. I have tried sterile water and bac water. I have injected the bac water, sterile water, GHRP 2 and Mod Grf seperately to identify the problem. Its the GRF 1-29. I switched to Ipam with the same results. I have started taking zyrtec a half hour before I pin the peps. I am down to once at night because I get so many hives. I tried pinning IM and that seemed to help slightly as long as I kept the zyrtec going. Lately that has not been as effective either. I have researched the internet and many sites hoping for a solution. Can any of you help me with this?
thanks
flhse1

Are the hives appearing only post admin? Have you alternated sites? Did you get this reaction from different suppliers of the MOD 1-29? Hives would obviously be an allergic reaction. I remember some people not doing well on the 192 amino acid sequence GH years ago, but never from MOD 1-29. I guess it is possible.

Hives from peptides

The hives are only post injection and take several hours coming on. They would remind you of a bee sting. Very hard under the skin and a little red around the injection site. I used a compounding pharmacy Prescription for three months then went to research sites because of cost. I am on my fourth supplier all with good reviews. I testes to see what was causing the reaction because I had reconned once with sterile water instead of bac water. I injected bac water, sterile water, ghrp 2, and mod grf all in separate sites. The only one that reacted was the mod grf. I rotate sites belly to back and have im'd delts, tris and quad. Had a nasty nerve twitch that bent the pin in the quads one night so I gave up on quads. I am a stickler for clean prep both when reconning and pinning. I cut the last vial of mod grf with twice the bac water. It makes for larger injection each time but I was hoping it would help. I have a hive from last nights sub q injection on my back and a lump from this morning pw delt injection. They go away after a few days so I am considering going to mod grf w/dac to keep the welts down since I would only inject 2 x weekly and then I could go back to pinning 3 x daily with ghrp2. I know I will need to take a break at times but I could be more consistent than I can be now. I'm looking for the fat cutting and anti aging from the peps. Presently the calipers put me between 12-13% bf.
Thanks again for any help you can be.
Flhse1

Usually that happens with low grade peps or contaminated product. If you didn't get them from the pharmaceutical peps, then it has to be the quality of GRF 1-29 you are using. Alot of companies will get the peps from China since its much cheaper and a higher profit margin. I would continue changing suppliers until you find one that uses US peptides.

Is there some way I can msg you and get a recommendation from you. I can also pass on who I have bought from then

Figured it out

Sent you a pm. Thanks again for your help