Test'e gone cloudy?

Made 300mg/ml

Ba 1.2%
Bb 20%

Cools and goes cloudy, its an even cloud,

Iv googled and 1 reason could be water moisture, so I'm cooking at 150oC for 1hr,

Any other reasons???

Also once its heated again it clears...

Sent from my BlackBerry 8520using Tapatalk

Maybe you didn't hit the melting point of the test to keep it clear?

Test e is close to room temp tho so it should be impossible to crash at 20% bb??

Iv cooked it at 150oc for 50mins and iv put 6ml in a 10ml vial for it to cool quicker (not filtered)

So far its looking ok, its cool to touch (fingers crossed) the total ml has dropped tho so I assume some ba or bb has gone, but I will let it cool completely then add in some another 3ml ba and then some bb to bring it back to 300ml at a guess it looks like its lost 10ml volume.

Also maybe I filtered it too soon, maybe it was too hot? I sucked the oil into a syringe from the top so maybe with it being too hot?

Could filtering too hot taking the oil from the top of the jug cause the solvent to drop lower down till it cools?

Sort of like how oil sits ontop of water??

Just thinking out loud atm...

I'm going to give it 1hr and if this 6ml in the vial is clear them I'm g2g, add ba and abit more bb and possibly gso heat to blend it then vial it up.

Sent from my BlackBerry 8520using Tapatalk

Cooking it done the job its crystal clear now

Sent from my BlackBerry 8520using Tapatalk

Throw it on the microwave for 10 seconds and shake well after then use, probably have to keep doing that everytime before use.......probably it's the moisture like you said

Its completely clear now, cooking it for 50mins 150oC has done the job its been in 10ml vials cold for hours now.

Sent from my BlackBerry 8520using Tapatalk

stone14 said:

Made 300mg/ml

Ba 1.2%
Bb 20%

Cools and goes cloudy, its an even cloud,

Iv googled and 1 reason could be water moisture, so I'm cooking at 150oC for 1hr,

Any other reasons???

Also once its heated again it clears...

Sent from my BlackBerry 8520using Tapatalk

Click to expand...

did the test dissolve well when you made it, with nothing left in the solvents/oil? if so, the enanth should have been at a fairly high purity level..
next, is it filtered? if so, you are good, it is just crashing, there is nothing wrong with iit beyond that.. just warm it before injecting to avoid pip

Yeh it dissolved no problem clear, and it was once it cooled, but its sorted now, just needed cooked, must have been water moisture..

Sent from my BlackBerry 9320 using Tapatalk

cool!

Whenever I run across something like this I always follow a simple routine before notifying the source.

I heat some water in a sauce pan and place the vial in the hot water holding it with tongs completely submerged except for the top. I hold it there for roughly 3-4 minutes, pull it out and swirl,shake,whatever to get the compound back into suspension. Place back into the water for a few minutes and repeat. By this time the crystals/cloudiness should be gone. If it is, all good to go and it back into suspension and the product is ready to use. If not, contact the source and give a detailed PM/Email about the product and hope they follow through with customer service!