anyone created methyltrienolone in injectable oil form?

i think theirs a few recipe here for it, did u run a search on it here?
 
100mg Methyl Tenbolone 100ml @ 1mg/ml
97ml Ethyl Oleate
2ml Benzyl Alcohol

200mg Methyl Trenbolone 100ml @ 2mg/ml
95ml Grape Seed Oil
3ml Benzyl Alcohol
 
based on Methyl Tren's melting point (164-170 C), I would say that the closes recipe for this is Winstrol (Stanozolol) / Primo (Methenolone) recipe:

Winstrol/Stanozolol
Dose: 50mg/ml
To make 20ml

1. Use 1g of Winstrol/Stanozolol or Primo A
2. Use 19ml of oil (GSO or Canola)
3. Mix them together in a glass beaker

4. Use a microwave oven and heat for 4-5 minutes (for Winstrol/Stanozolol) or
2-3 minutes (for Primo, because it melts easier).

Be sure the beaker is not completely covered, so pressure doesn't build up.
Swirl till the powder is completely dissolved. If it's not completely dissolved, heat again for 2-3 minutes. Keep repeating this step if necessary.

5. Add in 0.2ml BA (to make 1%)

Edit: Wait for the oil to cool down before adding the BA. If the oil is hot or still warm, adding the BA could cause rapid cooling, which could lead to crystal formation and crash later on
 
That could HURT someone. Dose is in range of 0.5-1 mg and even at that dose is highly liver toxic

lol, i don't know much about it, but thats one hell of a stretch going from 1mg being toxic to making it 200mg/ml lol, but again i know nothing about it other then what i read here,
 
I never made methyltrienolone, I know a source that sells it and has posted in RED , do not do more than 1/3 cc. I.M.O. if you need something THAT potent, your just not working hard enough!
 
Back
Top