Powderguy
MuscleChemistry Registered Member
Fellas,
After trial and error I finally was able to get a stable test base recipe that works. I tried to document every step and had to adjust every addition of stuff I added but finally did it.
I will post how I did it and if there's any questions or anything unclear please let me know.
Here's what you will need:
20 ml TNE @ 50 mg/ml
1 gram Test Base powder
2 ml benzyl benzoate ( 10%)
0.2 ml benzyl alcohol (1%)
0.6 ml polysorbate80 (3%)
14.8 ml distilled water
MUST: Heat the powder -PEG-ba-ps80 until it melts and forms a clear substance ..then filter it as warm as possible.
I do it on 45 degrees C into a clean vial with distilled water where it will titrate (return from its fluid form into the solid form inside the vial).
You can add the benzyl alcohol to the water and heat the water, do not boil it. heat to the point of where it starts to steam then remove from heat.
It is best to heat the liquids first, then slowly add the Test base and continue to swirl until it becomes a clear substance.
When you filter it make SURE you vent the sterile vial as the substance will be warm and build pressure but it will start to titrate in the sterile vial and start to filter out of the solution but will make a suspension. As with all suspensions shake before use.
I'm working on the same recipe with Winny and will post that recipe as it works out. Good luck , follow the directions and any questions feel free to ask.
After trial and error I finally was able to get a stable test base recipe that works. I tried to document every step and had to adjust every addition of stuff I added but finally did it.
I will post how I did it and if there's any questions or anything unclear please let me know.
Here's what you will need:
20 ml TNE @ 50 mg/ml
1 gram Test Base powder
2 ml benzyl benzoate ( 10%)
0.2 ml benzyl alcohol (1%)
0.6 ml polysorbate80 (3%)
14.8 ml distilled water
MUST: Heat the powder -PEG-ba-ps80 until it melts and forms a clear substance ..then filter it as warm as possible.
I do it on 45 degrees C into a clean vial with distilled water where it will titrate (return from its fluid form into the solid form inside the vial).
You can add the benzyl alcohol to the water and heat the water, do not boil it. heat to the point of where it starts to steam then remove from heat.
It is best to heat the liquids first, then slowly add the Test base and continue to swirl until it becomes a clear substance.
When you filter it make SURE you vent the sterile vial as the substance will be warm and build pressure but it will start to titrate in the sterile vial and start to filter out of the solution but will make a suspension. As with all suspensions shake before use.
I'm working on the same recipe with Winny and will post that recipe as it works out. Good luck , follow the directions and any questions feel free to ask.
