Fever? Bad Gear?

DEMIGOD

New member
So Friday night I started coming down with what I though might be the flu... Chills, fever and overall feeling of being ill. The next morning didn't feel quite as bad but through out the day I progressively felt similar to the night before which just hit me out of know where. My left glute was pretty sore and tight from my last pin of sust and tren ace on thursday which is typically not the case which was causing me to think that perhaps I injected to close to a blood vessel or my gear needs to be filtered and cleaned. But the fever was indication enough for me to go the Doc and get on some Bactrim DS (septra DS or Sulfamethoxazole and trimethoprim) in hopes of it not being an infection that could cause an abscess...


My question is should I... A.) sit on this gear and wait until I get the filter and new sterile vials which I ordered already and then resume pinning... this would be about a week B.) heat the vials in the oven to kill anything in the oil and pin as normal and filter it when the filters arrive or... C.) get new gear


I will mention as well I was only rotating sites between glutes every other day which I didn't realize was an issue and should be rotated between more sites when injecting every other day...

I love the tren ace, I'm a little more easily agitated but other than that and an occasional crappy nights sleep the stuff has been a game changer!

Thanks for everyone's opinion..
 
I know that I have had the same feeling a time or two after a pin. Seems that the Test didn't absorb as it should have and I got real sore and started to get flu like symptoms. I started holding my pin for a few seconds and get it warm and them warming up my heading pad and putting it on my pin location to heat up the site. No more issue for me so far.


Good luck brother.
 
Usually whenever I start or in between tren ace cycle I do get fever too but nothing too serious
 
I would wait to get the filters-abscess is not something to play with

the long acting esters in the sust should hold you over
 
Feel for you brother. I just tried out some sustanon I just brewed, was ok for the first 4 pins but on the forth all hell broke loose. I started whinny then and injected both in the same site, 2 days later I was swelled up on my glute about the size of a grown man's hand. The next day it went about 1/3 of the way down my thigh. Could barely walk and bend over. Super painful for 5 days, on the fifth night I did get the chills but nothing came of it and were gone in the morning. I posted my problem, thinking I made a huge error in the brew or got bad raws. I was told that it might be a higher dose than I thought. The next pinning I only pinned .75 mg instead of 1 mg and everything was great. No pain with minimal swelling. Sorry I don't have much advice, but I definitely agree with dorian123 wait for the filters. Good luck brother and hope all works out for you.
 
Get rid of that gear do not try and filter it. And for gods sake the oven stuff is crap!!!! Have you bought from this source before?
You can pin your glutes which I never do. If I can't see it I do not pin it. I rotate between delts, ventros, and quad, both inner and outer.

- - - Updated - - -

Feel for you brother. I just tried out some sustanon I just brewed, was ok for the first 4 pins but on the forth all hell broke loose. I started whinny then and injected both in the same site, 2 days later I was swelled up on my glute about the size of a grown man's hand. The next day it went about 1/3 of the way down my thigh. Could barely walk and bend over. Super painful for 5 days, on the fifth night I did get the chills but nothing came of it and were gone in the morning. I posted my problem, thinking I made a huge error in the brew or got bad raws. I was told that it might be a higher dose than I thought. The next pinning I only pinned .75 mg instead of 1 mg and everything was great. No pain with minimal swelling. Sorry I don't have much advice, but I definitely agree with dorian123 wait for the filters. Good luck brother and hope all works out for you.
Got to ask bro you said you brewed it? Are you a chemist?
 
I would say look at your gear through the light. Put light up to the vial and see if you can see anything in it, particles, anything.
If your getting swelling and redness its an abscess, if its swelling and travels down the leg (site) with no redness and fever then its the antibacterial preservative (BA) in excess.
Your gear should be tossed in all honesty. I would not use it and not allow anyone else to use it to, it sucks but take the loss or it will be worse.

TJ124- D12Hazz has good advice and has seeked out info on what and how to do things. The directions he gave were good just the volume was off due to displacement so the mg/ml ration was higher and therefore he has site pain due to concentration. Basic knowledge can get you a long way, plus just following directions is easy enough to get thee job done.
 
I looked at the stuff in the light and it looked like there is a little bit of settlement in the oil... Gonna filter it when it arrives, perhaps I had pulled some of that into the syringe. The first week was fine with no problems at all then that just happened out of know where. :confused: I read that a .22um filter will pull any bacteria out, the only thing would be that a virus could get through.

My fever is gone and so is the general ill overall feeling.

My glute is not quite as tight or in pain anymore either. Could the Bactrim have kicked in that quick? Perhaps I just pulled some of that settlement in and coincidentally got sick at the same time...
 
That's probably the UGL, they let vials sit and they collect dust and then just put the liquid in them and cap them. It happens more than you know bro.
I wish you luck and if you continue using it even after filtering it get you some more Bactrim or Cephlex you might need it. Staph is no joke
 
Get rid of that gear do not try and filter it. And for gods sake the oven stuff is crap!!!! Have you bought from this source before?
You can pin your glutes which I never do. If I can't see it I do not pin it. I rotate between delts, ventros, and quad, both inner and outer.

- - - Updated - - -


Got to ask bro you said you brewed it? Are you a chemist?

No...... but i did sleep at a holiday inn last night. Don't mean to be disrespectful but save your comments for someone else. I have been seeing a lot of your post on here and you degrade everyone. This site is for people willing to help one another, not for putting people down. Thank you for your concern.
 
I had one source years ago...and every damn thing I ordered from them did that to me. Shit was harsh as hell. It worked great and was expensive, so I gutted it out for quite a while before I stopped using it. But, EVERY single injection would hurt like the damn devil for a couple days after and I'd get the flu-like symptoms the night of the injection. Heating before pinning helped a small amount, but I'd start popping the advil 6-8 hours after every injection, because I knew what was coming.
 
I'll have to give you guys a shot... I don't know if I can ask, so feel free not to answer, but do you ship US domestic? or would it be coming across the big blue
 
I looked at the stuff in the light and it looked like there is a little bit of settlement in the oil... Gonna filter it when it arrives, perhaps I had pulled some of that into the syringe. The first week was fine with no problems at all then that just happened out of know where. :confused: I read that a .22um filter will pull any bacteria out, the only thing would be that a virus could get through.

My fever is gone and so is the general ill overall feeling.

My glute is not quite as tight or in pain anymore either. Could the Bactrim have kicked in that quick? Perhaps I just pulled some of that settlement in and coincidentally got sick at the same time...
I say again bro dump it and get a better source. Like this site. I do not order from this site bit I hear it is high quality!
 
Back
Top