Mast P/Colestabol Ace Blend--Need Help

Tried to make Mast P/Colestabol Ace blend at 50mg/100mg per ml, respectively. I could not get the powder to dissolve into the solution even at 5% BA and 30% BB. I was heating and adding extra solvent for ions. Finally, I figured I'd better quit before all the heat FUBARED the hormones.

At that point, I decided to make some Mast P at 100mg/ml by itself. It went into solution at 2% BA and 20% without a hitch. I also then made some 1-T Cyp at 3% BA and 30% BB without any problems. Neither of these two solutions crashed or are painful whatsoever.

Still, now I have this cloudy mixed solution of Mast P and Colestabol Ace that I don't know how to fix. Any ideas as to how to salvage it? Sitting over night the solution separated with the cloudy part settling to the bottom and the clear part sitting on top. I'd hate to waste it. Any ideas?

Ideas yes, have I done them NO. with that said, you could always double the volume of oil. Its no doubt the colest. thats being the bitch here, oil it down to 25/50. That will allow you to add more solvent and you may find that you don't need 30% bb at those conc. you may want to start at 20 and see if that holds.

Most of the times you can save a small amount as long as you are prepared to use it within a week or so. Otherwise trying to save your solution and day-by-day giving extra amount of oil, bb or ba is a ridiculous idea. That mixture you can get rid of. Earlier or later it will start crystallizing.

Try again 2/20 ba/bb and heat it to their highest MP. Will stay in solution if you preheat your oil and heat the lot up again but no higher than BA's BP.

Good luck!