How about looking over my Var steps

Bros here is what i have gotten off here and plaining on doing,
look it over and tell me if you have any tips, also im just plaining on putting the finished product in a dropper and using it like that, maybe adding a flavor like was subjusted and labeling it something odd.

So Here is what im thinking right now.

Anavar:
Highest concentration made - 20mg/ml
Per 1 gram of Oxandrolone powder you will need:
9.8 ml's of PEG 300
39.2 ml's of 190 Proof Grain Alcohol


Step 1. Prepare a hot water bath. Boil water in microwave or on a pot. Once boiling starts remove from heat.

Step 2. Place PEG and powder in beaker.

Step 3. Place the beaker deep enough in to the water so that the hot water is level with the PEG and powder. Gently swirl or stir with a stir rod until solution is clear. Reheat water as needed.

Step 4. Allow PEG to cool some. Then add in your 190 proof alcohol. You don't have to do this drop by drop but don't just dump it in. Pour it in slowly.

Step 5. Stir or gently shake until mixed

it sounds so damn simple i just about dont think i got it all down.. anyone got anythink to add ???
Any advise is great!

it sounds good. If you are not set on doing it that way, may I recommend simply getting some extra light olive oil in the desired volume you want heat it till its lukewarm, take the var powder shake it up and you have a very simple var suspension. The fatty acids help with the absorption of the var also. Ive done 2 cycles using this method, and I loved the results I got from it. The only drawback I can see is if you dont like the taste of olive oil. I just measured it in a oral syringe and shot it down my throat. Sometimes I would chase it with a sip of my protein shake.

Thats a great idea! sounds very easy! will i need to warm it up every now and then to mix up the settled var?
thanks

So if i put 1 gram of powder in 100ml of oil i would have 10mg per mL right?
so then 50mL of oil mixed with 1000mg of powder sould result in 20mg per 1mL
or 20mg per cc
look right?

6RAW said:

So if i put 1 gram of powder in 100ml of oil i would have 10mg per mL right?
so then 50mL of oil mixed with 1000mg of powder sould result in 20mg per 1mL
or 20mg per cc
look right?

Click to expand...

Yes, that is correct. I would take out maybe 1/2-1ml of oil to allow for displacement of the powder. Anytime you want to add powder to a liquid you have to allow for powder displacement so that the total volume equals the desired amount. For example, if you want to add 3gms of a powder to 100mls of a liquid, you would have to take out maybe 2-3mls of liquid to reach 100mls. If you just added 3gms of a powder to 100mls, it would actually exceed 100mls.

6RAW said:

Thats a great idea! sounds very easy! will i need to warm it up every now and then to mix up the settled var?
thanks

Click to expand...

I never did, the only time I heated it up was when I first put the powder in the olive oil. I just shaked the hell out of it. The var will settle to the bottom so make sure you shake before each use. I dont see a problem with heating it up every now and then. Let me know how you like it if you decide to do it this way. What dosage are you starting at?

I think ill start at 20mg per day and work up to 40mg by week two, im also running 400mg per week of test prop and 400mg of Equi.
running HCG through out the cycle along with proviron

i dont know might bump that test up to 500 but i have done well in the past on lower doesages and want to recover easly also.